Convert plain text documentation to reStructuredText format and add
it to Sphinx TOC tree. No essential content change.

Signed-off-by: Bin Meng <bmeng.cn@gmail.com>

NAND flavors, like serial and parallel, have a lot in common and would
benefit to share code. Let's move raw (parallel) NAND specific code in a
raw/ subdirectory, to ease the addition of a core file in nand/ and the
introduction of a spi/ subdirectory specific to SPI NANDs.

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>

When U-Boot started using SPDX tags we were among the early adopters and
there weren't a lot of other examples to borrow from.  So we picked the
area of the file that usually had a full license text and replaced it
with an appropriate SPDX-License-Identifier: entry.  Since then, the
Linux Kernel has adopted SPDX tags and they place it as the very first
line in a file (except where shebangs are used, then it's second line)
and with slightly different comment styles than us.

In part due to community overlap, in part due to better tag visibility
and in part for other minor reasons, switch over to that style.

This commit changes all instances where we have a single declared
license in the tag as both the before and after are identical in tag
contents.  There's also a few places where I found we did not have a tag
and have introduced one.

Signed-off-by: Tom Rini <trini@konsulko.com>

zc770-xm011 is also added and supported. Reflect this in README.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>

NAND and QSPI devices are now supported, so mark
them as such.

Cc: Michal Simek <michal.simek@xilinx.com>
Signed-off-by: Ezequiel Garcia <ezequiel@vanguardiasur.com.ar>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>

Prior to this commit, ZC702 and ZC706 shared the same configuration
and were built as follows:

ZC702: make zynq_zc70x_defconfig && make
ZC706: make zynq_zc70x_defconfig && make DEVICE_TREE=zynq-zc706

This commit introduces separate configuration for them, which makes
the next commit much easier.

Going forward, the recommended build commands are:

ZC702: make zynq_zc702_defconfig && make
ZC706: make zynq_zc706_defconfig && make

Although the old work flow is still supported, CONFIG_TARGET_ZC70X
has been marked as deprecated.  If used, the warning message is
shown to prompt users to switch to the new scheme.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>

Updated doc/README.zynq to current status

Signed-off-by: Jagannadha Sutradharudu Teki <jaganna@xilinx.com>

Added support to find the bootmodes by reading
slcr bootmode register. this can be helpful to
autoboot the configurations w.r.t a specified bootmode.

Added this functionality on board_late_init as it's not
needed for normal initializtion part.

Signed-off-by: Jagannadha Sutradharudu Teki <jaganna@xilinx.com>

Information on zynq u-boot about
- zynq boards
- mainline status
- TODO

Signed-off-by: Jagannadha Sutradharudu Teki <jaganna@xilinx.com>