u-boot.git/doc/board, branch v2024.10

Update directories for new name of TF-A directories

2024-10-04T15:00:47Z

The TF-A URL was updated, as a result the name of the directory changed as part of the new git URL and not all the referenced directories were updated. Fixes: 0ec0207fe07 ("Update the ARM trusted firmware git URL") Signed-off-by: Peter Robinson

Update the ARM trusted firmware git URL

2024-10-03T15:08:29Z

The primary upstream URL for tf-a has moved, in some cases things like tags are not always pushed to the old URL so update the URLs to the primary upstream project URL. Signed-off-by: Peter Robinson

imx8ulp_evk: enable binman support

2024-08-13T11:28:24Z

Enable binman support and add documentation for the imx8ul-evk board. Signed-off-by: Gary Bisson

board: rockchip: Add Radxa ROCK 5 ITX

2024-08-12T07:43:44Z

The Rock 5 ITX is a board in ITX form factor using the RK3588 SoC It can be powered either by 12V, ATX power-supply or PoE. Notable peripherals are the 4 SATA ports, M.2 M-Key slot, M.2 E-key slot, 2*2.5Gb PCIe-connected Ethernet NICs. Display options are 2*HDMI, DP via USB-c, eDP + 2*DSI via PCB connectors. USB ports are 4*USB3 + 2*USB2 on the back panel and 2-port front-panel connector. Schematics for the board can be found on - https://dl.radxa.com/rock5/5itx/radxa_rock_5_itx_X1100_schematic.pdf - https://dl.radxa.com/rock5/5itx/v1110/radxa_rock_5itx_v1110_schematic.pdf The naming scheme with the dashes follows Dragan's comment on the mainline devicetree commit: "the name of this board deviates from the standard Radxa naming scheme, which is something like "ROCK " thus, "rock-5a" is fine, but it should be "rock-5-itx", simply because there's a space between "5" and "ITX" in "ROCK 5 ITX" Signed-off-by: Heiko Stuebner Reviewed-by: Kever Yang Signed-off-by: Kever Yang

board: rockchip: Add FriendlyElec CM3588 NAS

2024-08-09T10:35:24Z

The CM3588 NAS by FriendlyElec pairs the CM3588 compute module, based on the Rockchip RK3588 SoC, with the CM3588 NAS Kit carrier board. Features tested on a CM3588 NAS Kit with 8GB RAM 64GB eMMC module: - SD-card boot - eMMC boot - Ethernet - PCIe/NVMe - USB gadget - USB host Signed-off-by: Jonas Karlman Reviewed-by: Kever Yang

board: rockchip: Add Xunlong Orange Pi 3B

2024-08-09T10:35:24Z

The Xunlong Orange Pi 3B is a single-board computer based on the Rockchip RK3566 SoC. The two hw revisions use different io-voltage for Ethernet PHY and can be identified using GPIO4_C4: - v1.1.1: x (internal pull-down) - v2.1: PHY_RESET (external pull-up) Implement rk_board_late_init() to set correct fdtfile env var and board_fit_config_name_match() to load correct FIT config based on what board is detected at runtime so a single board target can be used for both hw revisions. Minimal DTs that includ DT from dts/upstream is added to support booting from both hw revision and only set Ethernet PHY io-voltage when the hw revision is detected at runtime. A side-affect of this is that defconfig show OF_UPSTREAM=n, however dts/upstream DTs is used for this board. Features tested on Orange Pi 3B 4GB (v1.1.1 and v2.1): - SD-card boot - eMMC boot - SPI Flash boot - Ethernet - PCIe/NVMe - USB host Signed-off-by: Ricardo Pardini Co-developed-by: Jonas Karlman Signed-off-by: Jonas Karlman Reviewed-by: Kever Yang

board: rockchip: Add Radxa ZERO 3W/3E

2024-08-09T10:35:23Z

The Radxa ZERO 3W/3E is an ultra-small, high-performance single board computer based on the Rockchip RK3566, with a compact form factor and rich interfaces. Implement rk_board_late_init() to set correct fdtfile env var and board_fit_config_name_match() to load correct FIT config based on what board is detected at runtime so a single board target can be used for both board models. Features tested on a ZERO 3W 8GB v1.11: - SD-card boot - eMMC boot - USB gadget - USB host Features tested on a ZERO 3E 4GB v1.2: - SD-card boot - Ethernet - USB gadget - USB host Signed-off-by: Jonas Karlman Tested-by: FUKAUMI Naoki Reviewed-by: Kever Yang

board: rockchip: Add Radxa ROCK 3B

2024-08-09T10:35:23Z

The Radxa ROCK 3B is a single-board computer based on the Pico-ITX form factor (100mm x 75mm). Two versions of the ROCK 3B exists, a community version based on the RK3568 SoC and an industrial version based on the RK3568J SoC. Features tested on ROCK 3B 8GB v1.51 (both variants): - SD-card boot - eMMC boot - SPI Flash boot - Ethernet - PCIe/NVMe - USB gadget - USB host Signed-off-by: Jonas Karlman Tested-by: FUKAUMI Naoki Reviewed-by: Kever Yang

board: rockchip: add Radxa ROCK 3 Model C

2024-08-09T10:35:23Z

Based on rock-3a-rk3568_defconfig. Tested on v1.31 revision. Board Specifications: - Rockchip RK3566 - 1/2/4GB LPDDR4 2112MT/s - eMMC socket - uSD card slot - M.2 2230 Connector - GbE LAN with POE - 3.5mm jack with mic - HDMI 2.0, MIPI DSI/CSI - USB 3.0 Host, USB 2.0 Host/OTG - 40-pin GPIO expansion ports Signed-off-by: Maxim Moskalets Suggested-by: Jonas Karlman Reviewed-by: Jonas Karlman Tested-by: FUKAUMI Naoki Reviewed-by: Kever Yang

board: rockchip: Add Radxa ROCK S0

2024-08-09T10:35:23Z

Radxa ROCK S0 is a single-board computer based on the Rockchip RK3308B SoC in an ultra-compact form factor. Add a board target for the board. Features tested on a ROCK S0 v1.2 with 512 MiB RAM and 8 GiB eMMC: - SD-card boot - eMMC boot - Ethernet - USB gadget - USB host Signed-off-by: Jonas Karlman Reviewed-by: Kever Yang