u-boot.git/doc/device-tree-bindings/usb, branch v2018.07

usb: dwc3: Add dwc3 glue driver support for STi

2017-09-22T11:39:59Z

This patch adds the ST glue logic to manage the DWC3 HC on STiH407 SoC family. It configures the internal glue logic and syscfg registers. Part of this code been extracted from kernel.org driver (drivers/usb/dwc3/dwc3-st.c) Signed-off-by: Patrice Chotard Reviewed-by: Simon Glass

mvebu: usb: xhci: Add VBUS regulator supply to the host driver

2017-03-23T07:45:25Z

The USB device should linked to VBUS regulator through "vbus-supply" DTS property. This patch adds handling for "vbus-supply" property inside the USB device entry for turning on the VBUS regulator upon the host adapter probe. Signed-off-by: Konstantin Porotchkin Cc: Stefan Roese Cc: Marek Vasut Cc: Nadav Haklai Cc: Neta Zur Hershkovits Cc: Igal Liberman Cc: Haim Boot Acked-by: Marek Vasut Signed-off-by: Stefan Roese

ehci: Add support for Qualcomm EHCI

2016-04-01T21:18:11Z

This driver is able to reconfigure OTG controller into HOST mode. Board can add board-specific initialization as board_prepare_usb(). It requires USB_ULPI_VIEWPORT enabled in board configuration. Signed-off-by: Mateusz Kulikowski Acked-by: Marek Vasut Tested-by: Simon Glass

tegra: fdt: Add additional USB binding

2012-03-29T06:12:48Z

This adds a property to indicate a port which can switch between host and device mode. Signed-off-by: Simon Glass Acked-by: Stephen Warren Signed-off-by: Tom Warren

fdt: Add tegra-usb bindings file from linux

2012-03-29T06:12:48Z

This file is taken from the Linux mailing list. Signed-off-by: Simon Glass Signed-off-by: Tom Warren