updates documentation with explanation on how to select ECC schemes.

Signed-off-by: Pekon Gupta <pekon@ti.com>

GPMC controller needs to be configured based on bus-width of the NAND device
connected to it. Also, dynamic detection of NAND bus-width from on-chip ONFI
parameters is not possible in following situations:
SPL:    SPL NAND drivers does not support ONFI parameter reading.
U-boot: GPMC controller iniitalization is done in omap_gpmc.c:board_nand_init()
        which is called before probing for devices, hence any ONFI parameter
        information is not available during GPMC initialization.

Thus, OMAP NAND driver expected board developers to explicitely write GPMC
configurations specific to NAND device attached on board in board files itself.
But this was troublesome for board manufacturers as they need to dive into
lengthy platform & SoC documents to find details of GPMC registers and
appropriate configurations to get NAND device working.

This patch instead adds existing CONFIG_SYS_NAND_BUSWIDTH_16BIT to board config
hich indicates that connected NAND device has x16 bus-width. And then based on
this config GPMC driver itself initializes itself based on NAND bus-width. This
keeps board developers free from knowing GPMC controller specific internals.

Signed-off-by: Pekon Gupta <pekon@ti.com>

Commit 3d5a335c announced that all the nand_spl boards
would be removed before v2014.07 release.

Also update README.scrapyard.

Signed-off-by: Masahiro Yamada <yamada.m@jp.panasonic.com>

make the use of legacy image format configurable through
the config define CONFIG_IMAGE_FORMAT_LEGACY.

When relying on signed FIT images with required signature check
the legacy image format should be disabled. Therefore introduce
this new define and enable legacy image format if CONFIG_FIT_SIGNATURE
is not set. If CONFIG_FIT_SIGNATURE is set disable per default
the legacy image format.

Signed-off-by: Heiko Schocher <hs@denx.de>
Cc: Simon Glass <sjg@chromium.org>
Cc: Lars Steubesand <lars.steubesand@philips.com>
Cc: Mike Pearce <mike@kaew.be>
Cc: Wolfgang Denk <wd@denx.de>
Cc: Tom Rini <trini@ti.com>
Cc: Michal Simek <monstr@monstr.eu>
Acked-by: Simon Glass <sjg@chromium.org>

The Device Tree Compiler (DTC) used to have its master
repository located on jdl.com.  While it is still there,
its official, new, shiny location is on kernel.org here:

    git://git.kernel.org/pub/scm/utils/dtc/dtc.git

Update a few references to point there instead.

Signed-off-by: Jon Loeliger <jdl@jdl.com>
Acked-by: Simon Glass <sjg@chromium.org>

This board has been orphan for a while.
(Emails to its maintainer have been bouncing.)

Because MPC82xx family is old enough, nobody would pick up
the maintainership on it.

Signed-off-by: Masahiro Yamada <yamada.m@jp.panasonic.com>
Cc: Wolfgang Denx <wd@denx.de>

This board has been orphan for a while.
(Emails to its maintainer have been bouncing.)

Because MPC82xx family is old enough, nobody would pick up
the maintainership on it.

Signed-off-by: Masahiro Yamada <yamada.m@jp.panasonic.com>
Cc: Wolfgang Denx <wd@denx.de>

This board has been orphan for a while.
(Emails to its maintainer have been bouncing.)

Because MPC82xx family is old enough, nobody would pick up
the maintainership on it.

Signed-off-by: Masahiro Yamada <yamada.m@jp.panasonic.com>
Cc: Wolfgang Denx <wd@denx.de>