u-boot.git/doc, branch v2014.10-rc1

Change Andy Fleming's email address

2014-08-06T13:12:30Z

Messages to afleming@freescale.com now bounce, and should be directed to my personal address at afleming@gmail.com Signed-off-by: Andy Fleming

git-mailrc: add a kconfig alias

2014-08-06T13:02:46Z

It's easier to Cc Masahiro on Kconfig-related changes with a git-mailrc alias. Signed-off-by: Stephen Warren Acked-by: Masahiro Yamada

doc: README.SPL: adjust for Kbuild and Kconfig

2014-08-06T13:02:46Z

Reflect the latest build system to doc/README.SPL. Signed-off-by: Masahiro Yamada

doc: delete README.ARM-SoC

2014-08-06T13:02:46Z

This document is too old and useless. Signed-off-by: Masahiro Yamada

spi: Support half-duplex mode in FDT decode

2014-08-05T18:48:01Z

This parameter should also be supported. Signed-off-by: Simon Glass Tested-by: Ajay Kumar Reviewed-by: Jagannadha Sutradharudu Teki

include: define CONFIG_SPL and CONFIG_TPL as 1

2014-07-30T12:48:02Z

We are about to switch to Kconfig in the next commit. But there are something to get done beforehand. In Kconfig, include/generated/autoconf.h defines boolean CONFIG macros as 1. CONFIG_SPL and CONFIG_TPL, if defined, must be set to 1. Otherwise, when switching to Kconfig, the build log would be sprinkled with warning messages like this: warning: "CONFIG_SPL" redefined [enabled by default] Signed-off-by: Masahiro Yamada Reviewed-by: Simon Glass

Merge branch 'u-boot-ti/master' into 'u-boot-arm/master'

2014-07-28T10:26:21Z

ARM: omap: move board specific NAND configs out from ti_armv7_common.h

2014-07-25T20:26:12Z

This patch moves some board specific NAND configs: - FROM: generic config file 'ti_armv7_common.h' - TO: individual board config files using these configs. So that each board can independently set the value as per its design. Following configs are affected in this patch: CONFIG_SYS_NAND_U_BOOT_OFFS: CONFIG_CMD_SPL_NAND_OFS: CONFIG_SYS_NAND_SPL_KERNEL_OFFS: CONFIG_CMD_SPL_WRITE_SIZE: This patch also updates documentation for few of above NAND configs. Signed-off-by: Pekon Gupta

dm: Add child_pre_probe() and child_post_remove() methods

2014-07-23T13:08:37Z

Some devices (particularly bus devices) must track their children, knowing when a new child is added so that it can be set up for communication on the bus. Add a child_pre_probe() method to provide this feature, and a corresponding child_post_remove() method. Signed-off-by: Simon Glass

dm: Introduce per-child data for devices

2014-07-23T13:08:37Z

Some device types can have child devices and want to store information about them. For example a USB flash stick attached to a USB host controller would likely use this space. The controller can hold information about the USB state of each of its children. The data is stored attached to the child device in the 'parent_priv' member. It can be auto-allocated by dm when the child is probed. To do this, add a per_child_auto_alloc_size value to the parent driver. Signed-off-by: Simon Glass