Signed-off-by: Lukasz Majewski <lukma@denx.de>

This converts the following to Kconfig:
   CONFIG_BCH

Signed-off-by: Adam Ford <aford173@gmail.com>
Reviewed-by: Tom Rini <trini@konsulko.com>

Signed-off-by: Tom Rini <trini@konsulko.com>

Conflicts:
	configs/imx6qdl_icore_mmc_defconfig
	configs/imx6qdl_icore_rqs_defconfig

Instead of having separate code in the 'nvme' command, adjust it to use
the common function.

Signed-off-by: Bin Meng <bmeng.cn@gmail.com>

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

Writing prepared FDT to persistent storage should be possible in
scripts. Create environment variables containing address and size
of the updated FDT. Scripts can use these variables after running
'spl export fdt ...' command to write the new blob to persistent
storage.

Signed-off-by: Anatolij Gustschin <agust@denx.de>

Document the U-Boot Serial Download Protocol implementation and
some typical use cases.

Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
Reviewed-by: Łukasz Majewski <lukma@denx.de>

Add i2c driver which can be used on both STM32F7 and STM32H7.
This I2C block supports the following features:
 _ Slave and master modes
 _ Multimaster capability
 _ Standard-mode (up to 100 kHz)
 _ Fast-mode (up to 400 kHz)
 _ Fast-mode Plus (up to 1 MHz)
 _ 7-bit and 10-bit addressing mode
 _ Multiple 7-bit slave addresses (2 addresses, 1 with configurable mask)
 _ All 7-bit addresses acknowledge mode
 _ General call
 _ Programmable setup and hold times
 _ Easy to use event management
 _ Optional clock stretching
 _ Software reset

Signed-off-by: Christophe Kerello <christophe.kerello@st.com>
Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
Reviewed-by: Simon Glass <sjg@chromium.org>