u-boot.git/drivers/Makefile, branch v1.3.0-rc2

Add support for Sil680 IDE controller.

2007-09-06T21:53:11Z

o add drivers/sil680.c to support the Sil680 IDE-controller. o drivers/Makefile: add sil680.o. Signed-off-by: Gary Jennejohn

Update Makefiles for merged and split at45.c.

2007-08-14T09:30:06Z

Merge with git://www.denx.de/git/u-boot.git

2007-08-07T20:30:29Z

This is a framebuffer driver for ATI video card, can work for PCI9200,

2007-08-05T23:27:46Z

X300, X700, X800 ATI video cards. Signed-off-by: Zhang Wei Signed-off-by: Jason Jin

Make MPC8641's PCI/PCI-E driver a common driver for many FSL parts.

2007-08-05T22:22:24Z

All of the PCI/PCI-Express driver and initialization code that was in the MPC8641HPCN port has now been moved into the common drivers/fsl_pci_init.c. In a subsequent patch, this will be utilized by the 85xx ports as well. Common PCI-E IMMAP register blocks for FSL 85xx/86xx are added. Also enable the second PCI-Express controller on 8641 by getting its BATS and CFG_ setup right. Fixed a u16 vendor compiler warning in AHCI driver too. Signed-off-by: Ed Swarthout Signed-off-by: Zhang Wei Signed-off-by: Jon Loeliger

Merge with /home/wd/git/u-boot/custodian/u-boot-testing

2007-07-03T13:07:56Z

Add driver for S-ATA-controller on Intel processors with South

2007-05-15T21:25:37Z

Bridge, ICH-5, ICH-6 and ICH-7. Implementation: 1. Code is divided in to two files. All functions, which are controller specific are kept in "drivers/ata_piix.c" file and functions, which are not controller specific, are kept in "common/cmd_sata.c" file. 2. Reading and Writing from the S-ATA drive is done using PIO method. 3. Driver can be configured for 48-bit addressing by defining macro CONFIG_LBA48, if this macro is not defined driver uses the 28-bit addressing. 4. S-ATA read function is hooked to the File system, commands like ext2ls and ext2load file can be used. This has been tested. 5. U-Boot command "SATA_init" is added, which initializes the S-ATA controller and identifies the S-ATA drives connected to it. 6. U-Boot command "sata" is added, which is used to read/write, print partition table and get info about the drives present. This I have implemented in same way as "ide" command is implemented in U-Boot. 7. This driver is for S-ATA in native mode. 8. This driver does not support the Native command queuing and Hot-plugging. Signed-off-by: Mushtaq Khan

New board SMN42 branch

2007-05-09T10:37:56Z

Merge with git://www.denx.de/git/u-boot.git

2007-04-23T11:17:22Z

Cleanup, update CHANGELOG

2007-04-18T15:07:26Z

Sigend-off-by: Wolfgang Denk