u-boot.git/drivers/clk/kendryte/Kconfig, branch master

clk: k210: Move k210 clock out of its own subdirectory

2021-06-17T01:40:58Z

Now that we have only one clock driver, we don't need to have our own subdirectory. Move the driver back with the rest of the clock drivers. The MAINTAINERS for kendryte pinctrl is also fixed since it has always been wrong. Signed-off-by: Sean Anderson Reviewed-by: Leo Yu-Chi Liang

clk: k210: Rewrite to remove CCF

2021-06-17T01:40:57Z

This is effectively a complete rewrite to remove all dependency on CCF. The code is now smaller, and so is the binary. It also takes up less memory at runtime (since we don't have to create 40 udevices). In general, I am much happier with this driver as much of the complexity and late binding has been removed. The k210_*_params structs which were previously used to initialize CCF clocks are now used as the complete configuration. Since we can write our own division logic, we can now do away with several "half" clocks which only existed to provide constant factors of two. The clock IDs have been renumbered to remove unused clocks. This may not be the last time they are renumbered, since we have diverged with Linux. There are also still a few clocks left out which may need to be added back in. In general, I have tried to leave out behavioral changes. However, there is a small bugfix regarding ACLK. According to the technical reference manual, its mux comes *after* its divider (which is present only for PLL0). This would have required yet another intermediate clock to fix with CCF, but with the new driver it is just 2 lines of code :) Signed-off-by: Sean Anderson Reviewed-by: Leo Yu-Chi Liang

clk: Add K210 clock support

2020-07-01T07:01:21Z

Due to the large number of clocks, I decided to use the CCF. The overall structure is modeled after the imx code. Clocks parameters are stored in several arrays, and are then instantiated at run-time. There are some translation macros (FOOIFY()) which allow for more dense packing. Signed-off-by: Sean Anderson CC: Lukasz Majewski

clk: Add K210 pll support

2020-07-01T07:01:21Z

This pll code is primarily based on the code from the kendryte standalone sdk in lib/drivers/sysctl.c. k210_pll_calc_config is roughly analogous to the algorithm used to set the pll frequency, but it has been completely rewritten to be fixed-point based. Signed-off-by: Sean Anderson CC: Lukasz Majewski