If CONFIG_SYS_64BIT_LBA is enable, following compilation warning is
triggered:
CC drivers/fastboot/fb_mmc.o
../drivers/fastboot/fb_mmc.c: In function 'fb_mmc_erase_mmc_hwpart':
../drivers/fastboot/fb_mmc.c:215:35: warning: format '%lu' expects
argument of type 'long unsigned int', but argument 2 has type
'long long unsigned int' [-Wformat=]
215 | printf("........ erased %lu bytes from mmc hwpart[%u]\n",
| ~~^
| |
| long unsigned int
| %llu
216 | dev_desc->lba * dev_desc->blksz, dev_desc->hwpart);
| ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
| |
| long long unsigned int
../drivers/fastboot/fb_mmc.c: In function 'fb_mmc_boot_ops':
../drivers/fastboot/fb_mmc.c:261:42: warning: format '%lu' expects
argument of type 'long unsigned int', but argument 2 has type
'long long unsigned int' [-Wformat=]
261 | printf("........ wrote %lu bytes to EMMC_BOOT%d\n",
| ~~^
| |
| long unsigned int
| %llu
262 | blkcnt * blksz, hwpart);
| ~~~~~~~~~~~~~~
| |
| long long unsigned int
Signed-off-by: Patrice Chotard <patrice.chotard@foss.st.com>
Reviewed-by: Mattijs Korpershoek <mkorpershoek@baylibre.com>
Acked-by: Mattijs Korpershoek <mkorpershoek@baylibre.com>
Reviewed-by: Patrick Delaunay <patrick.delaunay@foss.st.com>
In getvar_partition_type() we attempt to find a filesystem driver for the partition (of the list of driver enabled in U-Boot), on failure we return the error to fastboot and completely bail out of the operation. However, this should not be a failure, instead we should just default to "raw". This allows commands like "fastboot format:ext4 userdata" to work if userdata didn't already have an ext4 partition table (or if FS_EXT4 is disabled in U-Boot), as failing to determine the current partition type is not an error in this case. Signed-off-by: Caleb Connolly <caleb.connolly@linaro.org> Reviewed-by: Mattijs Korpershoek <mkorpershoek@baylibre.com> Link: https://lore.kernel.org/r/20241113050607.1850472-1-caleb.connolly@linaro.org Signed-off-by: Mattijs Korpershoek <mkorpershoek@baylibre.com>
Prepare the introduction of the lwIP (lightweight IP) TCP/IP stack by
adding a new net/lwip/ directory and the NET_LWIP symbol. Network
support is either NO_NET, NET (legacy stack) or NET_LWIP. Subsequent
commits will introduce the lwIP code, re-work the NETDEVICE integration
and port some of the NET commands and features to lwIP.
SPL_NET cannot be enabled when NET_LWIP=y. SPL_NET pulls some symbols
that are part of NET (such as arp_init(), arp_timeout_check(),
arp_receive(), net_arp_wait_packet_ip()). lwIP support in SPL may be
added later.
Similarly, DFU_TFTP and FASTBOOT are not compatible with NET_LWIP
because of dependencies on net_loop(), tftp_timeout_ms,
tftp_timeout_count_max and other NET things. Let's add a dependency on
!NET_LWIP for now.
SANDBOX can select NET_LWIP but doing so will currently disable the eth
dm tests as well as the wget tests which have strong dependencies on the
NET code.
Other adjustments to Kconfig files are made to fix "unmet direct
dependencies detected" for USB_FUNCTION_SDP and CMD_FASTBOOT when
the default networking stack is set to NET_LWIP ("default NET_LWIP"
instead of "default NET" in Kconfig).
The networking stack is now a choice between NO_NET,
NET and NET_LWIP. Therefore '# CONFIG_NET is not set' should be
'CONFIG_NO_NET=y'. Adjust the defconfigs accordingly.
Signed-off-by: Jerome Forissier <jerome.forissier@linaro.org>
Acked-by: Ilias Apalodimas <ilias.apalodimas@linaro.org>
As part of bringing the master branch back in to next, we need to allow for all of these changes to exist here. Reported-by: Jonas Karlman <jonas@kwiboo.se> Signed-off-by: Tom Rini <trini@konsulko.com>
When bringing in the series 'arm: dts: am62-beagleplay: Fix Beagleplay Ethernet"' I failed to notice that b4 noticed it was based on next and so took that as the base commit and merged that part of next to master. This reverts commit c8ffd1356d42223cbb8c86280a083cc3c93e6426, reversing changes made to 2ee6f3a5f7550de3599faef9704e166e5dcace35. Reported-by: Jonas Karlman <jonas@kwiboo.se> Signed-off-by: Tom Rini <trini@konsulko.com>
Remove <common.h> from this driver directory and when needed add missing include files directly. Reviewed-by: Mattijs Korpershoek <mkorpershoek@baylibre.com> Signed-off-by: Tom Rini <trini@konsulko.com>
u-boot-dfu-20240419 - new "fastboot oem board" command
As reported by Jonas Karlman this series breaks booting on some AArch64 platforms with common use cases. For now the best path forward is to revert the series. This reverts commit 777c28460947371ada40868dc994dfe8537d7115, reversing changes made to ab3453e7b12daef47b9e91da2a2a3d48615dc6fc. Link: https://lore.kernel.org/u-boot/50dfa3d6-a1ca-4492-a3fc-8d8c56b40b43@kwiboo.se/ Signed-off-by: Tom Rini <trini@konsulko.com>
Currently, fastboot protocol in U-Boot has no opportunity to execute vendor custom code with verifed boot. This patch introduce new fastboot subcommand fastboot oem board:<cmd>, which allow to run custom oem_board function. Default implementation is __weak. Vendor must redefine it in board/ folder with his own logic. For example, some vendors have their custom nand/emmc partition flashing or erasing. Here some typical command for such use cases: - flashing: $ fastboot stage bootloader.img $ fastboot oem board:write_bootloader - erasing: $ fastboot oem board:erase_env Signed-off-by: Alexey Romanov <avromanov@salutedevices.com> Reviewed-by: Mattijs Korpershoek <mkorpershoek@baylibre.com> Reviewed-by: Quentin Schulz <quentin.schulz@theobroma-systems.com> Link: https://lore.kernel.org/r/20240418100129.1691822-2-avromanov@salutedevices.com Signed-off-by: Mattijs Korpershoek <mkorpershoek@baylibre.com>
This hunk of the patch was missed when using "b4" to apply the series. Signed-off-by: Tom Rini <trini@konsulko.com>