Set BIT(10) when the function needs to be set, otherwise the setting is
ignored.

Fixes: 0cb160f1b629 ("scmi: pinctrl: add pinctrl driver for SCMI")
Signed-off-by: Dan Carpenter <dan.carpenter@linaro.org>
Signed-off-by: Peng Fan <peng.fan@nxp.com>

This driver adds the base support of pinctrl over SCMI.  The driver
does two main things.  First, it allows you to configure the initial
pin states.  Secondly, it's used a base to build a GPIO driver on
top of it.

To configure the states then add a pinmux config to the scmi_pinctrl
section:

        scmi_pinctrl: protocol@19 {
                reg = <0x19>;
                pinmux1: pinmux_test {
                        pinmux = <0 1 0xFFFFFFFF 18 1
                                  0 2 0xFFFFFFFF 18 1
                                  0 3 0xFFFFFFFF 18 1>;
                        function = "f_gpio1";
                        groups = "grp_1", "grp_3";
                };
        };

Under linux the pinctrl subsystem will parse the function and group
properties and use that to handle muxing.  However, under u-boot the
pin muxing is done using the "pinmux" property, which feeds raw SCMI
pinctrl PINCTRL_SETTINGS_CONFIGURE commands to the server.  The
numbers are: selector, identifier, function_id, config_type, and
config_value.  In the example above, it sets pins 1, 2, and 3 to 1.
The linux-kernel ignores this pinmux property.

Signed-off-by: Dan Carpenter <dan.carpenter@linaro.org>
Reviewed-by: Peng Fan <peng.fan@nxp.com>
Signed-off-by: Peng Fan <peng.fan@nxp.com>