This provides a way of simulating GPIOs by setting values which are seen
by the normal gpio_get/set_value() calls.

Signed-off-by: Simon Glass <sjg@chromium.org>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>

Signed-off-by: Joe Hershberger <joe.hershberger@ni.com>
Cc: Joe Hershberger <joe.hershberger@gmail.com>
Signed-off-by: Kim Phillips <kim.phillips@freescale.com>

* 'master' of git://git.denx.de/u-boot-nios:
  nios2: Offer ft_board_setup() capability and call fdt_fixup_ethernet().
  board/nios2-generic: Use altera_pio driver and remove board specific driver
  gpio: Add driver for Altera's PIO core
  nios2: Pseudo implement dcache_status/enable/disable()

Signed-off-by: Marek Vasut <marek.vasut@gmail.com>
Cc: Stefano Babic <sbabic@denx.de>
Cc: Wolfgang Denk <wd@denx.de>
Cc: Detlev Zundel <dzu@denx.de>

This driver may handle multiple PIO cores and thus needs to be
setup by calling the altera_pio_init() function within the early
board setup routine.

The driver comes with some extras, see below the copyleft header.

Signed-off-by: Joachim Foerster <joachim.foerster@missinglinkelectronics.com>
Tested-by: Thomas Chou <thomas@wytron.com.tw>
Signed-off-by: Thomas Chou <thomas@wytron.com.tw>

Signed-off-by: Dirk Eibach <eibach@gdsys.de>

This patch adds generic GPIO driver framework support for Marvell SoCs.

To enable GPIO driver define CONFIG_MARVELL_GPIO and for GPIO commands
define CONFIG_CMD_GPIO in your board configuration file.

Signed-off-by: Ajay Bhargav <ajay.bhargav@einfochips.com>

Add a generic GPIO driver for the DaVinci DA8xx processors. It is turned
on by defining CONFIG_DA8XX_GPIO and fulfills the generic GPIO interface
specified in <asm/gpio.h> . The driver has support for both manipulating
GPIO pins as well as automatically configuring the pin multiplexor
registers to set the pin function to GPIO.

Signed-off-by: Laurence Withers <lwithers@guralp.com>
Signed-off-by: Sandeep Paulraj <s-paulraj@ti.com>

Signed-off-by: Tom Warren <twarren@nvidia.com>

Most of the Marvell SoCs has Multi Function Pin (MFP) configuration registers
For ex. ARMADA100.

These registers are programmed to expose the specific functionality
associated with respective SoC Pins

This driver provides configuration APIs,
using them, configuration need to be done in board specific code

for ex- following code configures MFPs 107 and 108 for UART_TX/RX functionality

int board_early_init_f(void)
{
        u32 mfp_cfg[] = {
                /* Console on UART1 */
                MFP107_UART1_RXD,
                MFP108_UART1_TXD,
                MFP_EOC         /*End of configureation*/
        };
        /* configure MFP's */
        mfp_config(mfp_cfg);
        return 0;
}

Signed-off-by: Prafulla Wadaskar <prafulla@marvell.com>