u-boot.git/drivers/inca-ip_sw.c, branch master

drivers/net : move net drivers to drivers/net

2007-11-25T17:35:17+00:00

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD

drivers/[a-m]*: Remove obsolete references to CONFIG_COMMANDS

2007-07-09T22:30:23+00:00

Signed-off-by: Jon Loeliger

drivers/: Augment CONFIG_COMMANDS tests with defined(CONFIG_CMD_*).

2007-07-03T22:23:11+00:00

This is a compatibility step that allows both the older form
and the new form to co-exist for a while until the older can
be removed entirely.

All transformations are of the form:
Before:
    #if (CONFIG_COMMANDS & CFG_CMD_AUTOSCRIPT)
After:
    #if (CONFIG_COMMANDS & CFG_CMD_AUTOSCRIPT) || defined(CONFIG_CMD_AUTOSCRIPT)

Signed-off-by: Jon Loeliger

Patch by Markus Pietrek, 04 May 2004:

2004-06-09T00:10:59+00:00

Fix clear_bss code for ARM systems (all except s3c44b0 which
doesn't clear BSS at all?)

Fix LOWBOOT configuration for MPC5200 with DDR memory

2004-03-11T22:46:36+00:00

* Fix SDRAM timings for LITE5200 / IceCube board

2004-03-02T14:05:39+00:00

* Handle Auti-MDIX / connection status for INCA-IP

* Fix USB problems when attempting to read 0 bytes

* Patch by Rahul Shanbhag, 19 Feb 2004:

2004-02-26T23:01:04+00:00

  Fixes for for OMAP1610 board:
  - shift some IRQ specific code to platform.S file
  - remove duplicatewatchdog reset code from start.S

* Make Auto-MDIX Support configurable on INCA-IP board

* Fix license for mkimage tool

* Patch by Travis Sawyer, 09 Feb 2004:

2004-02-22T23:46:08+00:00

  o 440GX:
    - Fix PCI Indirect access for type 1 config cycles with ppc440.
    - Add phymode for 440 enet
    - fix pci pre init
  o XPedite1K:
    - Change board_pre_init to board_early_init_f
    - Add user flash to bus controller setup
    - Fix pci pre init
    - Fix is_pci_host to check GPIO for monarch bit
    - Force xpedite1k to pci conventional mode (via #define option)

* Patch by Brad Kemp, 4 Feb 2004:
  - handle the machine check that is generated during the PCI scans
    on 82xx processors.
  - define the registers used in the IMMR by the PCI subsystem.

* Patch by Pierre Aubert, 03 Feb 2004:
  cpu/mpc5xxx/start.S: copy MBAR into SPR311

* Patch by Jeff Angielski, 03 Feb 2004:
  Fix copy & paste error in cpu/mpc8260/pci.c

* Patch by Reinhard Meyer, 24 Jan 2004:
  Fix typo in cpu/mpc5xxx/pci_mpc5200.c

Add Auto-MDIX support for INCA-IP

2004-02-20T22:02:48+00:00

* Make Ethernet autonegotiation on INCA-IP work for all clock rates;

2003-08-17T18:55:18+00:00

  allow selection of clock frequency as "make" target

* Implement memory autosizing code for IceCube boards

* Configure network port on INCA-IP for autonegotiation

* Fix overflow problem in network timeout code

* Patch by Richard Woodruff, 8 Aug 2003:
  Allow crc32 to be used at address 0x000 (crc32_no_comp, too).