This converts the following to Kconfig:
   CONFIG_TWL4030_LED
   CONFIG_TWL4030_INPUT

This also removes dead references to:
   CONFIG_TWL4030_KEYPAD

Signed-off-by: Adam Ford <aford173@gmail.com>

Add driver for the IHS IO endpoint on IHS FPGAs.

Signed-off-by: Mario Six <mario.six@gdsys.cc>

Following next kernel rcc bindings, we must use a MFD
RCC driver which is able to bind both clock and reset
drivers.

We can reuse and adapt RCC MFD driver already available
for MCU SoCs (F4/F7/H7).

Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
Signed-off-by: Patrick Delaunay <patrick.delaunay@st.com>

Add support of fuse command (read/write/program/sense)
on bank 0 to access to BSEC SAFMEM (4096 OTP bits).

Signed-off-by: Patrick Delaunay <patrick.delaunay@st.com>
Signed-off-by: Patrice Chotard <patrice.chotard@st.com>

Add a driver for RXAUI control on IHS FPGAs.

Signed-off-by: Mario Six <mario.six@gdsys.cc>
Reviewed-by: Simon Glass <sjg@chromium.org>

This patch added Kconfig support for CONFIG_ZYNQ_GEM_I2C_MAC_OFFSET
and enabled it in respective defconfig.

Signed-off-by: Vipul Kumar <vipulk@xilinx.com>
Signed-off-by: Siva Durga Prasad Paladugu <sivadur@xilinx.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>

This patch adds the support of reset and clock control
block (rcc) found on STM32 SoCs.
This driver is similar to a MFD linux driver.

This driver supports currently STM32H7 only.
STM32F4 and STM32F7 will be migrated to this rcc MFD driver
in the future to uniformize all STM32 SoCs already upstreamed.

Signed-off-by: Christophe Kerello <christophe.kerello@st.com>
Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
Reviewed-by: Vikas Manocha <vikas.manocha@st.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

This option is an SPL-variant of the I2C_EEPROM option to enable
the driver for generic I2C-attached EEPROMs for SPL.

Signed-off-by: Wenyou Yang <wenyou.yang@microchip.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

Add the following options to drivers/misc/Kconfig:
	SYS_I2C_EEPROM_ADDR
	SYS_I2C_EEPROM_BUS
	SYS_EEPROM_SIZE
	SYS_EEPROM_PAGE_WRITE_BITS
	SYS_EEPROM_PAGE_WRITE_DELAY_MS
	SYS_I2C_EEPROM_ADDR_LEN
	SYS_I2C_EEPROM_ADDR_OVERFLOW

This does not migrate any boards, but provides a foundations for
those who want/need these options

Signed-off-by: Adam Ford <aford173@gmail.com>
[trini: Migrate uniphier]
Signed-off-by: Tom Rini <trini@konsulko.com>

This module can be found on the Turris Omnia board connected
via the I2C interface.

Among some cryptographic functions, the chip has a 512 bit
One Time Programmable memory, 88 byte configuration memory
and 512 byte general purpose memory.

The Turris Omnia stores serial number and device MAC address in
the OTP memory.

This commit adds basic support for reading the EEPROM and also
exposes the chips Random Number Generator.

The driver is based on code by
  Josh Datko, Cryptotronix, jbd@cryptotronix.com
and also
  Tomas Hlavacek, CZ.NIC, tomas.hlavacek@nic.cz

Signed-off-by: Tomas Hlavacek <tomas.hlavacek@nic.cz>
Signed-off-by: Marek Behun <marek.behun@nic.cz>

 create mode 100644 drivers/misc/atsha204a-i2c.c
 create mode 100644 include/atsha204a-i2c.h
Signed-off-by: Stefan Roese <sr@denx.de>