The compatible values used for device nodes representing Renesas Reduced
Pin Count Interfaces were based on preliminary versions of the Device
Tree Bindings.

Correct them in both DTSi files and drivers, to match the final DT
Bindings.

Note that there are no DT bindings for RPC-IF on RZ/A1 yet, hence the
most logical SoC-specific value is used, without specifying a
family-specific value.

Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>

Move this out of the common header and include it only where needed.

Signed-off-by: Simon Glass <sjg@chromium.org>

This converts the following to Kconfig:
   CONFIG_SYS_FLASH_QUIET_TEST

Signed-off-by: Tom Rini <trini@konsulko.com>

This converts the following to Kconfig:
   CONFIG_SYS_MAX_FLASH_SECT

Signed-off-by: Tom Rini <trini@konsulko.com>

A large number of files include <flash.h> as it used to be how various
SPI flash related functions were found, or for other reasons entirely.
In order to migrate some further CONFIG symbols to Kconfig we need to
not include flash.h in cases where we don't have a NOR flash of some
sort enabled.  Furthermore, in cases where we are in common code and it
doesn't make sense to try and further refactor the code itself in to new
files we need to guard this inclusion.

Signed-off-by: Tom Rini <trini@konsulko.com>

As the only pic32 platform does not enable flash, this is dead code.
Remove it.

Cc: Purna Chandra Mandal <purna.mandal@microchip.com>
Signed-off-by: Tom Rini <trini@konsulko.com>

This converts the following to Kconfig:
   CONFIG_SYS_FLASH_ERASE_TOUT
   CONFIG_SYS_FLASH_LOCK_TOUT
   CONFIG_SYS_FLASH_UNLOCK_TOUT
   CONFIG_SYS_FLASH_WRITE_TOUT

In practice, for two m68k platforms we move to hard-coding with a
comment the timeout values, rather than try and make convoluted Kconfig
logic.  We add options for the write and erase options to the pic32
flash driver, as this driver does make use of them.  Everywhere else
these are unreferenced values.

Signed-off-by: Tom Rini <trini@konsulko.com>

This converts the following to Kconfig:
   CONFIG_SYS_FLASH_CHECKSUM

Signed-off-by: Tom Rini <trini@konsulko.com>

This converts the following to Kconfig:
   CONFIG_SYS_FLASH_EMPTY_INFO

Signed-off-by: Tom Rini <trini@konsulko.com>

Linux kernel uses compatible string "marvell,armada370-nand-controller" for
nand controllers on Armada 370/XP/38x. U-Boot currently uses mix of
"marvell,armada370-nand" and "marvell,mvebu-pxa3xx-nand".

So unify it and use just Linux kernel compatible string.

Signed-off-by: Pali Rohár <pali@kernel.org>
Acked-by: Michael Trimarchi <michael@amarulasolutions.com>
Reviewed-by: Stefan Roese <sr@denx.de>