u-boot.git/drivers/net/macb.c, branch v2015.01

net: macb: enable GMAC IP without GE feature support

2014-11-17T13:47:18+00:00

The User Register in GMAC IP is used to select interface type.
When with GE feature, it is used to select interface between
RGMII and GMII. If without GE feature, it is used to select
interface between MII and RMII.

Signed-off-by: Bo Shen 
Signed-off-by: Andreas Bießmann

net: macb: write mac address when initialization

2014-11-17T13:47:15+00:00

When boot up without mac address setting, it will give the warning
message like: "Warning: failed to set MAC address", however when
execute network related command, it still execute them without any
warning information.

With this patch, it will exit directly with following information:
"gmac0: mac address is not valid"

It also solve the problem after bootup then set mac address and the
mac address won't set to net device issue.

Signed-off-by: Bo Shen 
Tested-by: Boris Brezillon 
Signed-off-by: Andreas Bießmann

macb: simplify gmac initialisation

2014-10-10T19:51:15+00:00

Signed-off-by: Andreas Bießmann 
Cc: Joe Hershberger 
Cc: Bo Shen

net: macb: enable dcache in macb

2014-06-14T16:07:01+00:00

Add to code to flush the dcache after we writing in DMA buffer.
Also we need invalidate the dcache before we check the status in the
DMA buffer.

Tested in SAMA5D3x-EK with gmac0. Tftp download speed shows in below:
	Disable DCache: 1.1 MiB/s
	Enable DCache: 1.6 MiB/s
Increase speed with about 40%.

The code should have no impact with the boards which are not
enable_dcache().
Tested in AT91SAM9M10G45EK.

Signed-off-by: Josh Wu 
Signed-off-by: Andreas Bießmann

macb: make checkpatch clean

2014-06-14T16:07:00+00:00

This also renames the CONFIG_SYS_MACB_xx defines. They are used just local and
therefore don't need the CONFIG_SYS_ prefix.

Signed-off-by: Andreas Bießmann 
Reviewed-by: Josh Wu

net: macb: get DMA bus width from design config register

2013-11-04T19:32:31+00:00

Get DMA bus width from design config register

Signed-off-by: Bo Shen 
Signed-off-by: Andreas Bießmann

net: macb: fix the following building warning

2013-08-22T14:49:29+00:00

fix the following building warning
---8>---
macb.c: In function 'macb_init':
macb.c:400:14: warning: 'phydev' may be used uninitialized in this function
macb.c:377:21: note: 'phydev' was declared here
---<8---

Signed-off-by: Bo Shen 
Signed-off-by: Andreas Bießmann

Add GPL-2.0+ SPDX-License-Identifier to source files

2013-07-24T13:44:38+00:00

Signed-off-by: Wolfgang Denk 
[trini: Fixup common/cmd_io.c]
Signed-off-by: Tom Rini

net: macb: add support for gigabit MAC

2013-06-25T00:11:16+00:00

Add gigabit MAC support in macb driver
  - using IP version to distinguish whether MAC is GMAC

Signed-off-by: Bo Shen

net: macb: using phylib to configure phy device

2013-06-25T00:11:15+00:00

using phylib to configure phy device in macb driver

Signed-off-by: Bo Shen