u-boot.git/drivers/net/phy, branch v2018.03

net: phy: smsc: Add SMSC LAN8741 support

2018-02-26T21:51:37+00:00

Signed-off-by: Arno Steffens 
Acked-by: Joe Hershberger

phy: Fix style violations

2018-02-26T21:48:55+00:00

Fix some style violations in the generic PHY management code.

Acked-by: Joe Hershberger 
Signed-off-by: Mario Six

net: phy: marvell 88e151x: Fix handling of bare RGMII interface type

2018-02-26T21:47:07+00:00

Commit 68e6ecadc551 ("net: phy: marvell 88e151x: Fix handling of RGMII
interface types") fixed the initialization of 88e151x phys, but made it
so that interfaces of type PHY_INTERFACE_MODE_RGMII had both RX and TX
delay bits cleared. The default (like in m88e1111s_config) is to have
both bits set.

Hence, this patch changes the behavior in the PHY_INTERFACE_MODE_RGMII
case so that both bits are set.

Signed-off-by: Mario Six 
Acked-by: Joe Hershberger

net: phy: marvell: Fix style violations

2018-02-26T21:46:09+00:00

Fix some style violations (mostly wrong indentions) in the Marvell PHY
driver.

Acked-by: Joe Hershberger 
Signed-off-by: Mario Six

Kconfig: net: phylib: Phylib should depends on NET

2018-02-08T17:48:10+00:00

There is no value to enable phylib without networking support.

Signed-off-by: Michal Simek 
Acked-by: Joe Hershberger

phy: atheros: set auto-negotiation for AR8021

2018-01-15T18:05:27+00:00

Signed-off-by: Zhao Qiang 
Acked-by: Joe Hershberger

net: phy: b53: Add b53_reg read/write commands

2018-01-15T18:05:22+00:00

Add a b53_reg read/write command which allows inspecting the switch
registers. Because the Broadcom BCM53xx registers have different sizes,
we need to split the accesses in 8, 16, 32, 48 or 64 bits to obtain
expected results.

Reviewed-by: Stefan Roese 
Acked-by: Joe Hershberger 
Signed-off-by: Florian Fainelli

net: phy: Add Broadcom BCM53xx switch driver

2018-01-15T18:05:21+00:00

Add a minimalistic Broadcom BCM53xx (roboswitch) switch driver similar
to the Marvell MV88E617x. This takes care of configuring the minimum
amount out of the switch hardware such that each user visible port
(configurable) and the CPU port can forward packets between each other
while preserving isolation with other ports.

This is useful for e.g: the Lamobo R1 board featuring a Broadcom
BCM53125 switch.

Reviewed-by: Stefan Roese 
Signed-off-by: Florian Fainelli

net: miiphybb: fix casting error

2018-01-15T18:05:17+00:00

Since the return value is a signed int, if the leading MSB of rdreg is a 1,
it will get signed extended and will return a negative value which is an
error even though we read the correct value.

Fixes: dfcc496ed7e2 ("net: mii: Changes not made by spatch")
Signed-off-by: Chris Brandt 
Acked-by: Nobuhiro Iwamatsu 
Acked-by: Joe Hershberger

net: phy: marvell: Add functions to read PHY's extended registers

2018-01-15T18:05:16+00:00

This commit allows extended Marvell registers to be read with:

foo > mdio rx FEC 3.10
Reading from bus FEC
PHY at address 0:
3.16 - 0x1063
foo > mdio wx FEC 3.10 0x1011

The above code changes the way ETH connector LEDs blink.

Signed-off-by: Lukasz Majewski 
Reviewed-by: York Sun 
Acked-by: Joe Hershberger