u-boot.git/drivers/net/phy, branch v2018.07

net: phy: mv88e61xx: Force CPU port link up

2018-06-13T18:54:17+00:00

When connecting to from a CPU direct to a 88e6097 typically RGMII is
used. In order for traffic to actually pass we need to force the link up
so the CPU MAC on the other end will see the link.

Signed-off-by: Chris Packham 
Acked-by: Joe Hershberger

net/phy/cortina: Add support for CS4223 PHY

2018-06-13T18:54:15+00:00

Add support for Cortina CS4223 10G PHY
  - As per the CS4223 specs, an EEPROM module is
    connected to the PHY. At startup the PHY reads
    the firmware line and tries to load the firmware
    into the internal memory.
  - This driver reads the EEPROM status
    and checks if firmware has been loaded

Signed-off-by: Vicentiu Galanopulo 
Acked-by: Joe Hershberger

SPDX: Convert all of our single license tags to Linux Kernel style

2018-05-07T13:34:12+00:00

When U-Boot started using SPDX tags we were among the early adopters and
there weren't a lot of other examples to borrow from.  So we picked the
area of the file that usually had a full license text and replaced it
with an appropriate SPDX-License-Identifier: entry.  Since then, the
Linux Kernel has adopted SPDX tags and they place it as the very first
line in a file (except where shebangs are used, then it's second line)
and with slightly different comment styles than us.

In part due to community overlap, in part due to better tag visibility
and in part for other minor reasons, switch over to that style.

This commit changes all instances where we have a single declared
license in the tag as both the before and after are identical in tag
contents.  There's also a few places where I found we did not have a tag
and have introduced one.

Signed-off-by: Tom Rini

Remove unnecessary instances of DECLARE_GLOBAL_DATA_PTR

2018-04-27T18:54:48+00:00

We have a large number of places where while we historically referenced
gd in the code we no longer do, as well as cases where the code added
that line "just in case" during development and never dropped it.

Signed-off-by: Tom Rini

net: phy: Don't limit phy addresses by default

2018-04-13T20:56:47+00:00

Some boards expect to find more than one phy while other boards are old
and need to be limited to a specific phy address. Only limit the phy
address for boards that opt in.

Signed-off-by: Joe Hershberger 
Tested-by: Bin Meng 
Acked-by: Neil Armstrong 
Reviewed-by: Philipp Tomsich

net: phy: xilinx_phy: Read phytype using property xlnx,phy-type

2018-04-09T10:14:51+00:00

This patch reads phytype from property "xlnx,phy-type" instead
od simply looking for "phy-type". This is to be inline with
Linux and also fixes the issue of detecting it wrongly in
u-boot.

Signed-off-by: Siva Durga Prasad Paladugu 
Signed-off-by: Michal Simek 
Acked-by: Joe Hershberger

net/phy/cortina: Add No firmware upload option

2018-03-22T20:05:31+00:00

Current Cortina phy driver assumes that firmware upload
is required during initialization and is dependent
on presence of corresponding macros like CONFIG_CORTINA_FW_ADDR
for compilation.

But Cortina phy has provision to store phy firmware in
attached dedicated EEPROM. And boards designed with such
EEPROM does not require firmware upload.

Add CORTINA_NO_FW_UPLOAD option in cortina.c to support
such boards.

Signed-off-by: Priyanka Jain 
Acked-by: Joe Hershberger

net/phy/cortina.c: Update get_phy_id implementation

2018-03-22T20:05:31+00:00

Update get_phy_id() implementation in cortina.c to check
for Cortina_phy by comparing device phy_id with cortina phy_id
instead of relying on presence of CORTINA macros.

This will allow get_phy_id to work with non-cortina phy devices
which might have same phy address as Cortina device but on
different  bus.

Signed-off-by: Priyanka Jain 
Acked-by: Joe Hershberger

drivers: net: phy: Fix aquantia compilation with DM

2018-03-22T20:05:28+00:00

With CONFIG_DM_ETH enabled, aquantia driver compilation fails with
below error. This patch fixes the issue by including dm.h.

drivers/net/phy/aquantia.c: In function ‘aquantia_startup’:
drivers/net/phy/aquantia.c:73:21: error: dereferencing pointer to
incomplete
type ‘struct udevice’
          phydev->dev->name);
		     ^~

Signed-off-by: Calvin Johnson 
Acked-by: Joe Hershberger

net: phy: Add PHY_RTL8211E_PINE64_GIGABIT_FIX for realtek phys

2018-03-22T20:05:27+00:00

Setting PHY_RTL8211E_PINE64_GIGABIT_FIX forces internal rx/tx delays off
on the PHY, as well as flipping some magical undocumented bits. The
magic number comes from the Pine64 engineering team, presumably as a
proxy from Realtek. This configuration fixes the throughput on some
Pine64 models. Packet loss of up to 60-70% has been observed without
this.

Signed-off-by: Kyle Evans 
Acked-by: Joe Hershberger