Set the default for MV88E61XX_FIXED_PORTS to 0x0 in Kconfig, and move
the comment from code to the help to explain what this does.

Signed-off-by: Tom Rini <trini@konsulko.com>
Reviewed-by: Ramon Fried <rfried.dev@gmail.com>

Perform a simple rename of CONFIG_PHY_ET1011C_TX_CLK_FIX to CFG_PHY_ET1011C_TX_CLK_FIX

Signed-off-by: Tom Rini <trini@konsulko.com>

As DM_ETH is required for all network drivers, it's now safe to
remove the non-DM_ETH support code.

Signed-off-by: Tom Rini <trini@konsulko.com>

With DM_ETH being required now for all drivers, we don't need this
listed on individual drivers as well.

Signed-off-by: Tom Rini <trini@konsulko.com>

Add a driver for the Intel XWAY GbE PHY:
 - configure RGMII using dt phy-mode and standard delay properties
 - use genphy_config

Signed-off-by: Tim Harvey <tharvey@gateworks.com>

Fix a couple of typos:
- s/Acquantia/Aquantia/
- s/firmare/firmware/

Signed-off-by: Tim Harvey <tharvey@gateworks.com>
Reviewed-by: Ramon Fried <rfried.dev@gmail.com>

Add the handling of NC-SI ethernet frames, and add a check at the start
of net_loop() to configure NC-SI before starting other network commands.

Signed-off-by: Samuel Mendoza-Jonas <sam@mendozajonas.com>
Signed-off-by: Joel Stanley <joel@jms.id.au>
Reviewed-by: Cédric Le Goater <clg@kaod.org>
Reviewed-by: Ramon Fried <rfried.dev@gmail.com>

We check if phydev is NULL. Only but if it is non-NULL we set one
component of phydev. But even if it is NULL we set another. We should not
dereference NULL in either case.

Fixes: e24b58f5ed4f ("net: phy: don't require PHY interface mode during PHY creation")
Signed-off-by: Heinrich Schuchardt <heinrich.schuchardt@canonical.com>
Reviewed-by: Marek Behún <kabel@kernel.org>

The convinience functions are not that small and they caused
bloated text segments because of their usage.
There was no need to inline them in the first place, as
they're not part of a fastpath.

Signed-off-by: Ramon Fried <rfried.dev@gmail.com>
Reviewed-by: Michael Trimarchi <michael@amarulasolutions.com>
Reviewed-by: Marek Behún <kabel@kernel.org>
Reviewed-by: Vladimir Oltean <vladimir.oltean@nxp.com>

This patch adds basic support for the Marvell 88E1240 PHY.

This will be used by the upcoming ethernet support addition for the
Marvell MIPS Octeon EBB7304 platform.

Signed-off-by: Stefan Roese <sr@denx.de>
Cc: Ramon Fried <rfried.dev@gmail.com>
Cc: Joe Hershberger <joe.hershberger@ni.com>
Cc: Aaron Williams <awilliams@marvell.com>
Cc: Chandrakala Chavva <cchavva@marvell.com>
Reviewed-by: Marek Behún <marek.behun@nic.cz>