u-boot.git/drivers/net, branch v2020.07-rc4

Merge https://gitlab.denx.de/u-boot/custodians/u-boot-mpc85xx

2020-06-08T12:51:59Z

- DM_ETH support for P2041RDB, T1024RDB, P5040DS, P3041DS, P4080DS, bug fixes - Add TBI PHY access through MII - DDR: Rework errata workaround for A008109, A008378, 009942

net: tsec: Access TBI PHY through the corresponding MII

2020-06-04T13:23:20Z

When an eTSEC is configured to use TBI, configuration of the TBI is done through the MIIM registers for that eTSEC. For example, if a TBI interface is required on eTSEC2, then the MIIM registers starting at offset 0x2_5520 are used to configure it. Fixes: 9a1d6af55ecd ("net: tsec: Add driver model ethernet support") Signed-off-by: Hou Zhiqiang Reviewed-by: Vladimir Oltean Tested-by: Vladimir Oltean Reviewed-by: Priyanka Jain

net: tsec: Access eTSEC registers using virtual address

2020-06-04T13:23:20Z

The current code accesses eTSEC registers using physical address directly, it's not correct, though no problem on current platforms. It won't work on platforms, which does not support 1:1 virtual-physical address map. Signed-off-by: Hou Zhiqiang Reviewed-by: Vladimir Oltean Tested-by: Vladimir Oltean Reviewed-by: Priyanka Jain

net: tsec: fsl_mdio: add DM MDIO support

2020-06-04T13:23:14Z

Allow the MDIO devices to be probed based on the device tree. Signed-off-by: Madalin Bucur Signed-off-by: Priyanka Jain

drivers: net: e1000: with DM_ETH needs DM_PCI too

2020-06-03T06:44:27Z

Compilation error occur when DM_ETH is enabled without DM_PCI. Signed-off-by: Madalin Bucur Reviewed-by: Priyanka Jain

net: sun8i_emac: Add support for the H6 variant

2020-06-01T17:08:37Z

The H6 EMAC is very similar to the H3 variant, except that it uses the same pinmux as R40. Add support for it. Signed-off-by: Samuel Holland Reviewed-by: Jagan Teki

net: sun8i_emac: Use consistent clock bitfield definitions

2020-06-01T17:08:22Z

While the R40 uses a different register for EMAC clock configuration than other chips, the register has a very similar layout. Reuse the existing bitfield definitions in this file, since they match. This allows the driver to compile on the H6 platform, where the CCM_GMAC_CTRL definitions are not present. Signed-off-by: Samuel Holland Reviewed-by: Jagan Teki

net: ks8851: Add Kconfig entries

2020-05-22T17:46:45Z

Convert CONFIG_KS8851_MLL and CONFIG_KS8851_MLL_BASEADDR to Kconfig Signed-off-by: Marek Vasut Cc: Eugen Hristev Cc: Joe Hershberger

net: ks8851: Add DM support

2020-05-22T17:46:45Z

Add support for U-Boot DM and DT probing. Signed-off-by: Marek Vasut Cc: Eugen Hristev Cc: Joe Hershberger

net: ks8851: Receive one packet per recv call

2020-05-22T17:46:45Z

Instead of reading out the entire FIFO and possibly overwriting U-Boot memory, read out one packet per recv call, pass it to U-Boot network stack, and repeat. It is however necessary to cache RXFC value, because reading that one out clears it. Signed-off-by: Marek Vasut Cc: Eugen Hristev Cc: Joe Hershberger