u-boot.git/drivers/qe/qe.c, branch v2018.03

blk: Remove various places that do flush cache after read

2017-09-15T12:05:10Z

All these places seem to inherit the codes from the MMC driver where a FIXME was put in the comment. However the correct operation after read should be cache invalidate, not flush. The underlying drivers should be responsible for the cache operation. Remove these codes completely. Signed-off-by: Bin Meng Reviewed-by: Stefan Roese Reviewed-by: York Sun Reviewed-by: Joe Hershberger Reviewed-by: Simon Glass Tested-by: York Sun

QE: Set QE_IRAM_READY after uploading firmware

2017-09-11T14:55:36Z

QE_IRAM_READY should be set only after successfully uploading the firmware. Signed-off-by: Zhao Qiang Reviewed-by: York Sun

QE: add QE support on SD boot

2017-06-02T02:56:54Z

modify u_qe_init to upload QE firmware from SD card when it is SD boot Signed-off-by: Zhao Qiang Reviewed-by: York Sun

armv7: ls1021a: Drop macro CONFIG_LS102XA

2017-04-17T16:03:30Z

Use CONFIG_ARCH_LS1021A instead. Signed-off-by: York Sun

treewide: replace #include with

2016-09-23T21:55:42Z

Now, arch/${ARCH}/include/asm/errno.h and include/linux/errno.h have the same content. (both just wrap ) Replace all include directives for with . Signed-off-by: Masahiro Yamada [trini: Fixup include/clk.] Signed-off-by: Tom Rini

treewide: use #include <...> to include public headers

2016-09-23T21:53:56Z

We are supposed to use #include <...> to include headers in the public include paths. We should use #include "..." only for headers in local directories. Signed-off-by: Masahiro Yamada Reviewed-by: Simon Glass

board: ls1043ardb: Add micro QE support for ls1043ardb

2016-02-24T16:51:14Z

Signed-off-by: Zhao Qiang Reviewed-by: York Sun

driver: qe: Mask the codes not used for micro QE

2016-02-24T16:51:14Z

there are some code in qe.c not used for micro QE, use "#ifdef CONFIG_QE" to mask them. Signed-off-by: Zhao Qiang Reviewed-by: York Sun

qe: move drivers/qe/qe.h to include/fsl_qe.h

2016-02-24T16:51:13Z

As the QE firmware struct is shared with Fman, move the header file out of drivers/qe/. Signed-off-by: Gong Qianyu Reviewed-by: York Sun

driver/qe: use strncpy instead of strcpy

2015-08-03T19:06:36Z

strncpy is safer than strcpy, use it to instead of strcpy. Signed-off-by: Zhao Qiang Reviewed-by: York Sun