u-boot.git/drivers/serial/Makefile, branch v2025.04

global: Rename SPL_TPL_ to PHASE_

2024-10-11T17:44:48Z

Use PHASE_ as the symbol to select a particular XPL build. This means that SPL_TPL_ is no-longer set. Update the comment in bootstage to refer to this symbol, instead of SPL_ Signed-off-by: Simon Glass

global: Rename SPL_ to XPL_

2024-10-11T17:44:48Z

Use XPL_ as the symbol to indicate an SPL build. This means that SPL_ is no-longer set. Signed-off-by: Simon Glass

drivers: Use CONFIG_XPL_BUILD instead of CONFIG_SPL_BUILD

2024-10-11T17:44:48Z

Use the new symbol to refer to any 'SPL' build, including TPL and VPL Signed-off-by: Simon Glass

drivers: serial: Add xtensa semihosting driver

2024-07-04T22:08:37Z

Add xtensa semihosting driver. It can't use regular semihosting driver as Xtensa's has it's own semihosting ABI. Tested-by: Max Filippov Signed-off-by: Jiaxun Yang

drivers: serial: Add in UART for ADI SC5XX-family processors

2024-05-08T01:24:00Z

Co-developed-by: Greg Malysa Signed-off-by: Greg Malysa Co-developed-by: Ian Roberts Signed-off-by: Ian Roberts Signed-off-by: Vasileios Bimpikas Signed-off-by: Utsav Agarwal Signed-off-by: Arturs Artamonovs Signed-off-by: Nathan Barrett-Morrison

serial: mxs: Add MXS AUART driver

2023-05-21T14:54:41Z

Add trivial driver for the MXS AUART IP. This is the other UART IP present in i.MX23 and i.MX28, used to drive the non-DUART ports. Signed-off-by: Marek Vasut

arm: s5p4418: dm_serial: switch to DM_SERIAL

2023-01-02T21:06:08Z

Switch the S5P4418-SOC and therefore the s5p4418_nanopi2 board to DM_SERIAL. Signed-off-by: Stefan Bosch

kbuild: Remove uncmd_spl logic

2022-12-23T15:15:13Z

At this point in the conversion there should be no need to have logic to disable some symbol during the SPL build as all symbols should have an SPL counterpart. The main real changes done here are that we now must make proper use of CONFIG_IS_ENABLED(DM_SERIAL) rather than many of the odd tricks we developed prior to CONFIG_IS_ENABLED() being available. Signed-off-by: Tom Rini

arm: lpc32xx: Remove unused hsuart driver

2022-12-05T21:07:13Z

This driver is not enabled in any config currently, remove it. Cc: Trevor Woerner Signed-off-by: Tom Rini

Convert CONFIG_SYS_NS16550_MEM32 et al to Kconfig

2022-12-05T21:06:07Z

This converts the following to Kconfig: CONFIG_SPL_NS16550_MIN_FUNCTIONS CONFIG_SYS_NS16550_MEM32 CONFIG_SYS_NS16550_PORT_MAPPED CONFIG_SYS_NS16550_REG_SIZE CONFIG_SYS_NS16550_SERIAL To do this we also introduce CONFIG_SPL_SYS_NS16550_SERIAL so that platforms can enable the legacy driver here for SPL. Signed-off-by: Tom Rini