Number of Qualcomm ARMv7 SoC-s did not use PSCI but rather used PSHOLD
(Qualcomm Power Supply Hold Reset) bit to trigger reset or poweroff.

Qualcomm IPQ40XX is one of them, so provide a simple sysreset driver based
on the upstream Linux one, it is DT compatible as well.

Signed-off-by: Robert Marko <robert.marko@sartura.hr>
Reviewed-by: Caleb Connolly <caleb.connolly@linaro.org>
Signed-off-by: Caleb Connolly <caleb.connolly@linaro.org>

Add sysreset driver for cv1800b SoC

Signed-off-by: Kongyang Liu <seashell11234455@gmail.com>
Reviewed-by: Leo Yu-Chi Liang <ycliang@andestech.com>

This patch adds support for resetting a board via the RAA215300 PMIC.

Note that the RAA215300 documentation names the available reset types
differently to u-boot:

  * A "warm" reset via the RAA215300 PMIC will fully reset the SoC
    (CPU & GPIOs), so this corresponds to SYSRESET_COLD.

  * A "cold" reset via the RAA215300 PMIC will cycle all power supply
    rails, so this corresponds to SYSRESET_POWER.

Signed-off-by: Paul Barker <paul.barker.ct@bp.renesas.com>
Reviewed-by: Marek Vasut <marek.vasut+renesas@mailbox.org>

PALMAS PMIC family has embedded poweroff function used by some
device to initiane device power off. Implement it as sysreset
driver.

Signed-off-by: Svyatoslav Ryhel <clamor95@gmail.com>

TPS65910/TPS65911 PMICs have embedded power control functions
used by some device to initiane device power off. Implement it as
sysreset driver.

Signed-off-by: Svyatoslav Ryhel <clamor95@gmail.com>

TPS80031/TPS80032 PMICs have embedded power control functions
used by some device to initiane device power off. Implement it as
sysreset driver.

Signed-off-by: Svyatoslav Ryhel <clamor95@gmail.com>

MAX77663 PMIC has embedded poweroff function used by some
device to initiane device power off. Implement it as sysreset
driver.

Signed-off-by: Svyatoslav Ryhel <clamor95@gmail.com>

Tegra uses built in Power Management Controller (PMC) to perform
CPU reset. Code to perform this was located in mach-tegra, so lest
create DM driver to handle this.

Signed-off-by: Svyatoslav Ryhel <clamor95@gmail.com>

DM_GPIO depends on GPIO to be enabled but select will cause that DM_GPIO is
selected without GPIO which ends up in compilation error:
undefined reference to `dm_gpio_set_value'
undefined reference to `dm_gpio_get_value'
undefined reference to `dm_gpio_free'
undefined reference to `gpio_request_by_name'

Signed-off-by: Michal Simek <michal.simek@amd.com>
[trini: Fix configs which had relied on these select's]
Signed-off-by: Tom Rini <trini@konsulko.com>

System reset via the SRST extension in the SBI should be the default.
The driver checks if the extension is available when probing.
So there is no risk in enabling it.

Signed-off-by: Heinrich Schuchardt <heinrich.schuchardt@canonical.com>
Reviewed-by: Leo Yu-Chi Liang <ycliang@andestech.com>