u-boot.git/drivers/thermal, branch v2023.07

imx: move imx8 sci header file to include/firmware/imx

2023-05-21T14:54:32Z

Move imx8 sci header file to include/firmware/imx, then we could use build macro to reuse some i.MX8 drivers for i.MX9, such as drivers/cpu/imx8_cpu.c. Signed-off-by: Peng Fan Signed-off-by: Stefano Babic

thermal: imx_tmu: Update TMU driver to support iMX93

2023-05-21T11:48:52Z

The TMU used on iMX93 is IP revision 2.1 which is different with previous revision used on iMX8MQ. So add a new FLAG V4 for this revision to distinguish the operations. Reviewed-by: Peng Fan Signed-off-by: Ye Li Signed-off-by: Peng Fan

thermal: imx_tmu: Move architecture code into driver

2023-05-21T11:48:52Z

Stop polluting the architecture directory with driver specific code, move it into driver where it should be. Split the code slightly so the MX8MM/MX8MN fuse readout and programming and MX8MP fuse readout and programming are in their separate functions, and called in case of matching SoC. Signed-off-by: Marek Vasut Reviewed-by: Fabio Estevam Reviewed-by: Andrejs Cainikovs

thermal: imx_tmu: Clean up all prints

2023-05-21T11:48:52Z

Use dev_(dev, ...) for all printing and debug logging, since this already includes the device name. Drop device name where duplicate. Signed-off-by: Marek Vasut Reviewed-by: Fabio Estevam Reviewed-by: Andrejs Cainikovs

thermal: add sandbox driver

2022-10-11T20:03:03Z

Provide a simple sandbox driver for the thermal uclass. It simply registers and returns 100 degrees C if requested. Signed-off-by: Robert Marko Reviewed-by: Simon Glass

WS cleanup: remove SPACE(s) followed by TAB

2021-09-30T13:08:16Z

Signed-off-by: Wolfgang Denk

dm: define LOG_CATEGORY for all uclass

2021-07-06T16:38:03Z

Define LOG_CATEGORY for all uclass to allow filtering with log command. Signed-off-by: Patrick Delaunay Reviewed-by: Simon Glass

thermal: imx_tmu: enable monitoring and default alert/critical

2021-03-01T09:21:36Z

Set default critical/alert temperature and enabling monoitoring. Without calling imx_tmu_enable_msite() monitoring will not be enabled and read_temperature will return 0. Additionally without setting alert temperature will cause imx_tmu_get_temp() to spin indefiniately thinking the system needs to cool. This resolves the board spinning endlessly when enabling IMX_TMU in the SPL. Reviewed-by: Fabio Estevam Signed-off-by: Tim Harvey

common: Drop asm/global_data.h from common header

2021-02-02T20:33:42Z

Move this out of the common header and include it only where needed. In a number of cases this requires adding "struct udevice;" to avoid adding another large header or in other cases replacing / adding missing header files that had been pulled in, very indirectly. Finally, we have a few cases where we did not need to include at all, so remove that include. Signed-off-by: Simon Glass Signed-off-by: Tom Rini

dm: treewide: Rename ofdata_to_platdata() to of_to_plat()

2020-12-13T23:51:09Z

This name is far too long. Rename it to remove the 'data' bits. This makes it consistent with the platdata->plat rename. Signed-off-by: Simon Glass