u-boot.git/drivers/usb/host/Kconfig, branch v2018.01

usb: xhci: Add Renesas R-Car xHCI driver

2017-11-26T01:22:36Z

Add firmware V3, firmware loader and XHCI glue for the Renesas R-Car Gen3 SoCs XHCI controller. Thus far only the R-Car Gen3 R8A7795 ES2.0+ and R8A7796 are supported. Signed-off-by: Marek Vasut Cc: Nobuhiro Iwamatsu Cc: Bin Meng

usb: host: Move CONFIG_XHCI_FSL to Kconfig

2017-10-27T15:44:06Z

use Kconfig to select xhci accordingly. Signed-off-by: Ran Wang Reviewed-by: Bin Meng Reviewed-by: York Sun

usb: Drop the EHCI RCar Gen3

2017-10-03T23:50:43Z

Since we use EHCI generic driver on RCar Gen3 , this driver is useless. Remove it. Signed-off-by: Marek Vasut Cc: Nobuhiro Iwamatsu Acked-by: Nobuhiro Iwamatsu Signed-off-by: Nobuhiro Iwamatsu

usb: dwc3: Add dwc3 glue driver support for STi

2017-09-22T11:39:59Z

This patch adds the ST glue logic to manage the DWC3 HC on STiH407 SoC family. It configures the internal glue logic and syscfg registers. Part of this code been extracted from kernel.org driver (drivers/usb/dwc3/dwc3-st.c) Signed-off-by: Patrice Chotard Reviewed-by: Simon Glass

usb: ehci: Convert CONFIG_USB_EHCI_PCI to Kconfig

2017-08-21T09:30:44Z

This converts CONFIG_USB_EHCI_PCI to a Kconfig option, and updates all boards that use it. Signed-off-by: Bin Meng

usb: xhci-pci: Drop non-DM version of xhci-pci driver

2017-07-28T21:34:28Z

As there is no board that currently uses xhci-pci driver without DM USB, drop its support and leave only DM support. Signed-off-by: Bin Meng Reviewed-by: Simon Glass

usb: xhci: Convert CONFIG_USB_XHCI_PCI to Kconfig

2017-07-28T21:34:26Z

Add CONFIG_USB_XHCI_PCI as a Kconfig option. Signed-off-by: Bin Meng Reviewed-by: Simon Glass Reviewed-by: Stefan Roese Tested-by: Stefan Roese

usb: Kconfig: migrate USB_DWC2 to Kconfig

2017-07-11T10:13:49Z

This change migrates the USB_DWC2 configuration item to Kconfig and runs moveconfig to adjust header files and defconfig. Signed-off-by: Meng Dongyang Split off into a separate patch: Ran moveconfig to migrate other boards: Signed-off-by: Philipp Tomsich

usb: Kconfig: config USB_XHCI_ROCKCHIP depends on DM_REGULATOR and DM_USB

2017-07-11T10:13:48Z

The xhci-rockchip driver depends on DM_REGULATOR and DM_USB. So add dependent features for xhci-rockchip driver in Kconfig. Signed-off-by: Meng Dongyang Reviewed-by: Philipp Tomsich Acked-by: Philipp Tomsich

usb: ehci: Add Renesas RCar M3/H3 EHCI support

2017-05-22T09:47:27Z

Add a USB controller driver for the EHCI block in R8A7795/R8A7796 SoC. This is a stopgap measure until we have proper DT support, clock and reset framework in place, at which point we can switch to ehci-generic. Signed-off-by: Hiroyuki Yokoyama Signed-off-by: Marek Vasut Cc: Hiroyuki Yokoyama Cc: Nobuhiro Iwamatsu Reviewed-by: Nobuhiro Iwamatsu