u-boot.git/drivers/usb/host, branch v2013.10-rc2

usb: ehci-mx5: Use 'bool' instead of 'unsigned char'

2013-08-26T19:56:34Z

The 'enable' argument can be better expressed as boolean. Signed-off-by: Fabio Estevam Reviewed-by: Otavio Salvador

usb: ehci-mx5: Remove unneeded write to cscmr1 register

2013-08-26T19:56:34Z

Currently we have the following behavior in ehci_hcd_init() - Read csmr1 register, clear bit 26 and then set bit 26. However a little bit later we call set_usb_phy_clk() which clears bit 26, so let's get rid of the unnecessary code. Signed-off-by: Fabio Estevam

ARM: OMAP: USB: Fix linker error when ULPI is not defined

2013-08-26T19:55:46Z

Fix the linker error for missing ulpi_reset when ulpi is not defined in the board config. Signed-off-by: Dan Murphy Acked-by: Marek Vasut

ARM: OMAP5: USB: Add OMAP5 common USB EHCI information

2013-08-26T19:55:46Z

* Enable the OMAP5 EHCI host clocks * Add OMAP5 EHCI register definitions * Add OMAP5 ES2 host revision Signed-off-by: Dan Murphy

ehci-hcd: fix memory leak in lowlevel init

2013-07-29T21:01:33Z

usb_lowlevel_init() allocates a new periodic_list each time it is invoked, without freeing the original list. Since it is initialized later on in the code, just reuse the first-allocated list in future invocations of usb_lowlevel_init. Cc: Marek Vasut Cc: Igor Grinberg Signed-off-by: Nikita Kiryanov

usb: ehci-omap: Don't softreset USB High-speed Host (UHH) Module

2013-07-29T21:01:33Z

Fixes NFS root problems with Beagle (3530 ES1.0) when used with external USB-ethernet adapter and "USB start" command used within u-boot. Soft resetting the UHH module causes instability issues on all OMAPs so we just avoid it. See OMAP36xx Errata i571: USB host EHCI may stall when entering smart-standby mode i660: USBHOST Configured In Smart-Idle Can Lead To a Deadlock On OMAP4/5, soft-resetting the UHH module can put it into Smart-Idle mode and lead to a deadlock. On OMAP3 this doesn't seem to be the case but still instabilities are observed on beagle (3530 ES1.0) if soft-reset is used. e.g. NFS root failures with Linux kernel. Signed-off-by: Roger Quadros

usb: ehci: Split out struct ehci_ctrl definition

2013-07-29T21:01:31Z

Move the struct ehci_ctrl defition from ehci-hcd.c into ehci.h so it can be re-used by drivers. In particular, the mv_udc driver can benefit from this move. Signed-off-by: Marek Vasut Cc: Fabio Estevam Cc: Lei Wen Cc: Otavio Salvador Cc: Stefano Babic

Add GPL-2.0+ SPDX-License-Identifier to source files

2013-07-24T13:44:38Z

Signed-off-by: Wolfgang Denk [trini: Fixup common/cmd_io.c] Signed-off-by: Tom Rini

Merge branch 'master' of git://git.denx.de/u-boot-arm

2013-07-12T14:36:48Z

Fix a trivial conflict in arch/arm/dts/exynos5250.dtsi about gpio and serial. Conflicts: arch/arm/dts/exynos5250.dtsi Signed-off-by: Tom Rini

ARM: Tegra: USB: EHCI: Add support for Tegra30/Tegra114

2013-07-11T21:15:15Z

Tegra30 and Tegra114 are compatible except PLL parameters. Tested on Tegra30 Cardhu, and Tegra114 Dalmore platforms. All works well. Signed-off-by: Jim Lin Signed-off-by: Tom Warren