u-boot.git/drivers/usb/host, branch v2019.10-rc2

env: Move env_get() to env.h

2019-08-11T20:43:41Z

Move env_get() over to the new header file. Acked-by: Joe Hershberger Signed-off-by: Simon Glass

usb, ohci, pci: add DM support for PCI-based OHCI USB controller

2019-08-08T09:35:02Z

add new DM based PCI driver ohci-pci for PCI-based OHCI USB support. Signed-off-by: Heiko Schocher

usb, ohci: add warning if none on pci found

2019-08-08T09:35:02Z

Signed-off-by: Heiko Schocher

usb, ohci-hcd: set OHCI_USE_NPS if DM_PCI

2019-08-08T09:35:02Z

set OHCI_USE_NPS if DM_PCI is enabled. Signed-off-by: Heiko Schocher

usb, ohci: fix ohci swap register access

2019-08-08T09:35:02Z

commit 57faca19a82f ("drivers: USB: OHCI: allow compilation for 64-bit targets") broke ohci support for the mpc85xx based socrates board, as it removed volatile keyword from ohci_readl/writel. Fix this so usb works again on socrates board. Signed-off-by: Heiko Schocher

usb, ohci-hdc: fix warning 'ohci_pci_ids' defined but not used

2019-08-08T09:35:02Z

var ohci_pci_ids is only used if DM_USB is not enabled. So define this varaible only if !CONFIG_IS_ENABLED(DM_USB) Signed-off-by: Heiko Schocher

rockchip: xhci: Remove RK3399 support

2019-07-19T03:11:09Z

Remove RK3399 compatible strings as this driver is no longer used on that SoC. Signed-off-by: Mark Kettenis Reviewed-by: Kever Yang

usb: xhci-dwc3: Add USB2 PHY configuration

2019-07-19T03:11:09Z

Configure USB2 PHY register based on "phy_type" property and handle all the quirks that are relevant for Rockchip RK3399 SoCs. Signed-off-by: Mark Kettenis Reviewed-by: Kever Yang

usb: dwc3-of-simple: Add support for RK3399

2019-07-19T03:11:09Z

Add compatible string for RK3399 and enable it by default on Rockchip platforms with USB3 support. Signed-off-by: Mark Kettenis Reviewed-by: Kever Yang

usb: ehci-mx6: Fix bus enumeration for DM case

2019-07-05T12:19:40Z

The EHCI iMX6 driver is only partly converted to DT probing and still uses a tremendous amount of hard-coded addresses. Worse, the driver uses hard-coded SoC-model-specific base addresses, which are derived from values protected by SoC-specific macros, hence the driver is also compiled for a specific SoC model. Even worse, the driver depends on specific sequential indexing of the controllers, from which it derives offsets in the PHY and ANATOP register sets. However, when the driver is probed from DT, the indexing is not correct. In fact, each controller has index 0. This patch derives the index for DT probing case from the controller base addresses, which is not the way this should be done, however it is the least intrusive approach, favorable this close to release. The necessary steps to convert this driver fully to DT probing are described inside the patch, however this should be done in the next release and depends on iMX clock driver patches. Signed-off-by: Marek Vasut Cc: Abel Vesa Cc: Adam Ford Cc: Fabio Estevam Cc: Ludwig Zenz Cc: Lukasz Majewski Cc: Peng Fan Cc: Stefano Babic Cc: Vagrant Cascadian