u-boot.git/drivers/usb/ulpi, branch v2024.01

tree-wide: Replace http:// link with https:// link for ti.com

2023-11-10T16:01:50Z

Replace instances of http://www.ti.com with https://www.ti.com Signed-off-by: Nishanth Menon

global: Finish CONFIG -> CFG migration

2023-01-20T17:27:24Z

At this point, the remaining places where we have a symbol that is defined as CONFIG_... are in fairly odd locations. While as much dead code has been removed as possible, some of these locations are simply less obvious at first. In other cases, this code is used, but was defined in such a way as to have been missed by earlier checks. Perform a rename of all such remaining symbols to be CFG_... rather than CONFIG_... Signed-off-by: Tom Rini Reviewed-by: Simon Glass

common: Drop linux/delay.h from common header

2020-05-19T01:19:23Z

Move this uncommon header out of the common header. Signed-off-by: Simon Glass

common: Drop log.h from common header

2020-05-19T01:19:18Z

Move this header out of the common header. Signed-off-by: Simon Glass

SPDX: Convert all of our single license tags to Linux Kernel style

2018-05-07T13:34:12Z

When U-Boot started using SPDX tags we were among the early adopters and there weren't a lot of other examples to borrow from. So we picked the area of the file that usually had a full license text and replaced it with an appropriate SPDX-License-Identifier: entry. Since then, the Linux Kernel has adopted SPDX tags and they place it as the very first line in a file (except where shebangs are used, then it's second line) and with slightly different comment styles than us. In part due to community overlap, in part due to better tag visibility and in part for other minor reasons, switch over to that style. This commit changes all instances where we have a single declared license in the tag as both the before and after are identical in tag contents. There's also a few places where I found we did not have a tag and have introduced one. Signed-off-by: Tom Rini

usb: ulpi: kconfig: Remove meaningless choice default

2018-02-06T01:58:12Z

'default' on a choice refers to the symbol selected by default, not to the choice mode, so 'default n' is meaningless. No functional changes. Optional choices implicitly default to n mode (and there is no way to make them default to another mode). Discovered in Kconfiglib (https://github.com/ulfalizer/Kconfiglib), which prints the following warning: warning: the default selection n (undefined) of (defined at drivers/usb/ulpi/Kconfig:3) is not contained in the choice I've added a corresponding warning to the C tools too, which is currently in linux-next: https://patchwork.kernel.org/patch/9983667/ Signed-off-by: Ulf Magnusson

usb: ulpi: Fix compile warning in read/write on 64-bit machines.

2016-04-01T21:18:09Z

ulpi_read and ulpi_write are used to read/write registers via ULPI bus. Code generates compilation warnings on 64-bit machines where pointer is cast to u32. This patch drops all but last 8 bits of register address. It is possible, because addresses on ULPI bus are 6- or 8-bit. It is not possible (according to ULPI 1.1 spec) to have more than 8-bit addressing. This patch should not cause regressions as all calls to ulpi_read/write use either structure pointer (@ address 0) or integer offsets cast to pointer - addresses requested are way below 8-bit range. Signed-off-by: Mateusz Kulikowski Acked-by: Marek Vasut

usb: ulpi: Add Kconfig options for ULPI

2016-04-01T21:18:08Z

The following options can be now enabled via defconfig: - CONFIG_USB_ULPI - CONFIG_USB_ULPI_VIEWPORT - CONFIG_USB_ULPI_VIEWPORT_OMAP Signed-off-by: Mateusz Kulikowski Reviewed-by: Simon Glass Acked-by: Marek Vasut

Add more SPDX-License-Identifier tags

2016-01-19T13:31:21Z

In a number of places we had wordings of the GPL (or LGPL in a few cases) license text that were split in such a way that it wasn't caught previously. Convert all of these to the correct SPDX-License-Identifier tag. Signed-off-by: Tom Rini

drivers: usb: convert makefiles to Kbuild style

2013-10-31T17:25:38Z

Signed-off-by: Masahiro Yamada