u-boot.git/drivers, branch v2009.01

sh: serial: use readx/writex accessors

2009-01-16T02:59:20+00:00

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD 
Signed-off-by: Nobuhiro Iwamatsu

sh: serial: coding style cleanup

2009-01-16T02:03:17+00:00

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD 
Signed-off-by: Nobuhiro Iwamatsu

Merge branch 'master' of git://git.denx.de/u-boot-mpc85xx

2008-12-30T22:30:47+00:00

NAND FSL elbc: Use virt_to_phys to determine which bank is in use

2008-12-20T00:20:08+00:00

The current code that determines which bank/chipselect is used for a
given NAND instance only worked for 32-bit addresses and assumed
a 1:1 mapping.  This breaks in 36-bit physical configs.

The proper way to handle this is to use the virt_to_phys() and
BR_PHYS_ADDR() routinues to match the 34-bit lbc bus address
with the the virtual address the NAND code uses.

Signed-off-by: Kumar Gala 
Acked-by: Scott Wood

Add support for PCA953x I2C gpio devices

2008-12-20T00:11:49+00:00

Initial support for NXP's 4 and 8 bit I2C gpio expanders
(eg pca9537, pca9557, etc). The CONFIG_PCA953X define
enables support for the devices while the CONFIG_CMD_PCA953X
define enables the pca953x command. The CONFIG_CMD_PCA953X_INFO
define enables an 'info' sub-command which provides summary
information for the given pca953x device.

Signed-off-by: Peter Tyser

pci/fsl_pci_init: Enable inbound PCI config cycles

2008-12-20T00:10:45+00:00

Add fsl_pci_config_unlock() function to enable a
PCI/PCIe interface configured in agent/endpoint mode to
respond to inbound PCI configuration cycles.

Signed-off-by: Peter Tyser

NAND: Mark the BBT as scanned prior to calling scan_bbt.

2008-12-16T20:40:34+00:00

Otherwise, recursion can occur if scan_bbt does not find a bad block
table, and tries to write one, and the attempt to erase the BBT area
causes a bad block check.

Signed-off-by: Scott Wood

Coding style cleanup, update CHANGELOG.

2008-12-16T00:02:17+00:00

Signed-off-by: Wolfgang Denk

spi/stmicro: fix debug() display of cmd

2008-12-15T23:48:18+00:00

The stmicro_wait_ready() func tries to show the actual opcode that was sent
to the device, but instead it displays the array pointer.  Fix it to pull
out the opcode from the start of the array.

Signed-off-by: Mike Frysinger

i2c: merge all i2c_reg_read() and i2c_reg_write() into inline functions

2008-12-15T22:46:21+00:00

All implementations of the functions i2c_reg_read() and
i2c_reg_write() are identical. We can save space and simplify the
code by converting these functions into inlines and putting them in
i2c.h.

Signed-off-by: Timur Tabi 
Acked-By: Jean-Christophe PLAGNIOL-VILLARD