u-boot.git/drivers, branch v2010.09-rc2

mmc: fix compiler warnings

2010-09-19T10:30:54Z

Commit d2bf29e3 caused a number of compiler warnings: mmc.c: In function 'mmc_bwrite': mmc.c:97: warning: format '%x' expects type 'unsigned int', but argument 2 has type 'long unsigned int' mmc.c:97: warning: format '%x' expects type 'unsigned int', but argument 3 has type 'lbaint_t' mmc.c: In function 'mmc_bread': mmc.c:229: warning: format '%x' expects type 'unsigned int', but argument 2 has type 'long unsigned int' mmc.c:229: warning: format '%x' expects type 'unsigned int', but argument 3 has type 'lbaint_t' Fix these. Signed-off-by: Wolfgang Denk Cc: Lei Wen

mmc: add boundary check for mmc operation

2010-09-18T21:46:24Z

Signed-off-by: Lei Wen

nand/davinci: make sure ECC calculation has really started

2010-09-13T19:43:05Z

Due to a register glitch (result code <4 might show up right after the start-calculation-bit was set), make sure the ECC has really started. See 1c3275b656045aff9a75bb2c9f3251af1043ebb3 in the kernel. Signed-off-by: Wolfram Sang Cc: Sandeep Paulraj

usb: musb: set target address for non-multipoint devices

2010-09-11T07:49:22Z

Signed-off-by: Bryan Wu Signed-off-by: Cliff Cai Signed-off-by: Mike Frysinger

usb: musb: setup TXCOUNT for Blackfin musb

2010-09-11T07:49:21Z

The Blackfin implementation of musb has a TXCOUNT register that needs to be programmed when transmitting data. Signed-off-by: Bryan Wu Signed-off-by: Cliff Cai Signed-off-by: Mike Frysinger

Prepare v2010.09-rc1

2010-09-09T22:16:19Z

Coding style cleanup. Signed-off-by: Wolfgang Denk

Merge branch 'master' of git://git.denx.de/u-boot-ti

2010-09-09T17:55:02Z

mtd: nand: supress 'unknown NAND' warning if no nand is found

2010-09-08T18:51:29Z

This printk was added recently and results in ugly output on systems with no NAND: NAND: nand_get_flash_type: unknown NAND device: Manufacturer ID: 0x00, Chip ID: 0x00 0 MiB instead of: NAND: 0 MiB Signed-off-by: Steve Sakoman Acked-by: Scott Wood Signed-off-by: Sandeep Paulraj

ARMV7: OMAP: add convenience function to set TWL4030 regulator voltages

2010-09-08T18:50:23Z

This patch adds a function to allow one to easily set the target voltage for the TWL4030 regulators. It also modifies the existing code to use this new function. Applicable definitions are moved out of the driver file and into the header file so that they are generally accessible Signed-off-by: Steve Sakoman Signed-off-by: Sandeep Paulraj

Merge branch 'at91' of git://git.denx.de/u-boot-atmel

2010-09-07T22:42:00Z