Otherwise,  ocassionally see errors like this:
  Flashing sparse image at offset 2078720
  Flashing Sparse Image
  sdhci_send_command: Timeout for status update!
  mmc fail to send stop cmd
  write_sparse_image: Write failed, block #2181088 [0]

This does not affect the actual writing speed, which is controlled by
the default value:
  CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT

It only increases the retries when reading:
  SDHCI_INT_STATUS
to avoid the timeout error.

Signed-off-by: Steve Rae <steve.rae@raedomain.com>
Reviewed-by: Stefan Roese <sr@denx.de>
Tested-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Tested-by: Jaehoon Chung <jh80.chung@samsung.com>

Correcting QSPI disable/unselect CS reset value.
CTRL_CORE_CONTROL_IO_2: QSPI_MEMMAPPED_CS[10:8]

This is not causing any issue, but its better
to untouch the reserved bits.

Praneeth Bajjuri <praneeth@ti.com>
Signed-off-by: Ravi Babu <ravibabu@ti.com>

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

SPL does not use all of the devices, so we can save some memory
footprint.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

PH1-LD4 and PH1-sLD8 SoCs have pins that support pin configuration
(pin biasing, drive strength control), but not pin-muxing.

Allow to fill the mux value table with -1 for those pins; pins with
mux value -1 will be skipped in the pin-mux set function.  The mux
value type should be changed from "unsigned" to "int" in order to
accommodate -1 as a special case.

[ Linux commit: 363c90e743b50a432a91a211dd8b078d9df446e9 ]

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

PH1-LD11 and PH1-LD20 have much pin controlling in common, so I
added a single driver shared between them in the initial commit.

However, the Ethernet pin-mux settings I am going to add are
different with each other, and they may diverge more as the
progress of development.  Split it into two dedicated drivers.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

Currently, the UniPhier pinctrl driver itself is a syscon, but it
turned out much more reasonable to make it a child node of a syscon
because our syscon node consists of a bunch of system configuration
registers, not only pinctrl, but also phy, and misc registers.
It is difficult to split the node.  This commit allows to migrate to
the new DT structure.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

This SoC does not support NAND CS1.  This place-holder is no longer
necessary.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

My mistake in the initial support patch.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>