If the OOB size is not multiple of the cache line size, the ARMv7
cache operation still prints "Misaligned operation at range".

=> nand info

Device 0: nand0, sector size 256 KiB
  Page size       4096 b
  OOB size         224 b
  Erase size    262144 b
  subpagesize     4096 b
  options     0x00104200
  bbt options 0x00060000
=> nand dump 0
CACHE: Misaligned operation at range [9fb15280, 9fb16360]
CACHE: Misaligned operation at range [9fb15280, 9fb16360]
CACHE: Misaligned operation at range [9fb15280, 9fb16360]
CACHE: Misaligned operation at range [9fb15280, 9fb16360]
  ...

The cache flushing operations won't happen in this case to cover all of
the range to fix this by making sure we have things aligned.

Reported-by: Marek Vasut <marex@denx.de>
Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
[trini: Reword the commit message to be clear this is a direct problem
rather than just a warning]

The existing imx_watchdog driver is compatible with mx25 chipsets.
Add a WDOG1_BASE_ADDR define for the base address and enable the driver
in watchdog's Makefile.

To use the driver, a board must define CONFIG_IMX_WATCHDOG and
CONFIG_HW_WATCHDOG.

This fixes an issue when booting an mx25 chip via usb/serial. In this
case, the boot rom will always enable the watchdog. If u-boot is running
in interactive mode and the watchdog is not serviced, the system is
rebooted when the watchdog expires.

Signed-off-by: Martin Kaiser <martin@kaiser.cx>
Reviewed-by: Fabio Estevam <fabio.estevam@nxp.com>

The dev_get_priv(dev) is used twice in the probe function.
Replace the second invocation with priv variable.

Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>
Cc: Masahiro Yamada <yamada.masahiro@socionext.com>
Cc: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>

Add code to reset all reset signals as in usb DT node. A reset property
is an optional feature, so only print out a warning and do not fail if a
reset property is not present.

If a reset property is discovered, then use it to deassert, thus
bringing the IP out of reset.

Signed-off-by: Ley Foon Tan <ley.foon.tan@intel.com>

Only PCI device 1 and 2 is populated on the R-Car Gen2 internal
PCIe controller. Ignore all other devices. This fix prevents a
duplication of OHCI controller response on slot 0 and 1.

Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>

Add support for operating a PHY attached to ehci-pci. There are
systems where the EHCI controller is internally wired to a PCI
bus and has a PHY connected to it as well, ie. the R-Car Gen2.

Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>

Pull out the EHCI PHY functions into the ehci-hcd.c to let other
EHCI drivers use them.

Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>