u-boot.git/drivers, branch v2025.10-rc4

MAINTAINERS: Add entry for DesignWare XGMAC driver

2025-09-08T15:16:18Z

Add a MAINTAINERS entry for the DesignWare XGMAC network driver to ensure future patches are properly routed for review and support. Signed-off-by: Boon Khai Ng Reviewed-by: Tom Rini

Merge branch 'master' of https://source.denx.de/u-boot/custodians/u-boot-samsung

2025-09-05T14:15:16Z

- Fix issues reported by smatch - exynos4210-origen cleanups - e850-96 improvements

spi: exynos: Remove extra term from test

2025-09-03T10:32:38Z

In spi_rx_tx there comes a test for execution of a code block that allows execution if rxp is not NULL or stopping is true. However all the code in this block relies on rxp being valid so allowing entry just if stopping is true does not make sense. So remove this from the test expression leaving just a NULL check for rxp. This issue was found by Smatch. Signed-off-by: Andrew Goodbody Signed-off-by: Minkyu Kang

pinctrl: rzg2l: Variable may not have been assigned to

2025-09-03T00:45:08Z

In rzg2l_pinconf_set and rzg2l_get_pin_muxing if the call to rzg2l_selector_decode fails then the variable pin may not have been assigned to. Remove the use of pin from the error message. Also update the error message to show the invalid selector used instead of port which will be the error code returned. This issue was found by Smatch. Signed-off-by: Andrew Goodbody Reviewed-by: Paul Barker Reviewed-by: Marek Vasut

Merge tag 'u-boot-rockchip-20250831' of https://source.denx.de/u-boot/custodians/u-boot-rockchip

2025-09-01T15:50:01Z

CI: https://source.denx.de/u-boot/custodians/u-boot-rockchip/-/pipelines/27522 - New Board support: rk3588 Xunlong Orange Pi 5 Ultra; rk3588s GameForce Ace; rk3576 ArmSoM Sige5; - rk3328 soc fixes; - usb controller and phy fixes; - new rk3328 ddr timing; - other board level updates;

usb: host: dwc3-of-simple: Add exynos850 compatible

2025-09-01T07:37:12Z

Enable support for Exynos850 SoC in DWC3 host glue layer driver. Signed-off-by: Sam Protsenko Reviewed-by: Marek Vasut Signed-off-by: Minkyu Kang

clk: exynos: Fix always true test

2025-09-01T07:37:08Z

In exynos7420_peric1_get_rate the variable ret is declared as an 'unsigned int' but is then used to receive the return value of clk_get_by_index which returns an int. The value of ret is then tested for being less than 0 which will always fail for an unsigned variable. Fix this by declaring ret as an 'int' so that the test for the error condition is valid. This issue was found by Smatch. Signed-off-by: Andrew Goodbody Signed-off-by: Minkyu Kang

efi: serial: Use correct EFI status type

2025-08-30T18:45:33Z

int is not sufficient to hold and test the return from an EFI function call. Use efi_status_t instead so that the test can work as expected. This issue was found by Smatch. Fixes: 275854baeeec ("efi: Add a serial driver") Signed-off-by: Andrew Goodbody Reviewed-by: Heinrich Schuchardt

phy: rockchip: typec: Fix improper use of UCLASS_PHY

2025-08-30T16:48:15Z

The Rockchip TypeC glue driver improperly present itself as a UCLASS_PHY driver, without ever implementing the required phy_ops. This is something that in special circumstances can lead to a NULL pointer dereference followed by a SError crash. Change the glue driver to use UCLASS_NOP to fix this. Signed-off-by: Jonas Karlman Reviewed-by: Kever Yang

phy: rockchip: inno-usb2: Fix improper use of UCLASS_PHY

2025-08-30T16:48:15Z

The Rockchip USB2PHY glue driver improperly present itself as a UCLASS_PHY driver, without ever implementing the required phy_ops. This is something that in special circumstances can lead to a NULL pointer dereference followed by a SError crash. Change the glue driver to use UCLASS_NOP to fix this. Signed-off-by: Jonas Karlman Reviewed-by: Kever Yang