u-boot.git/include/configs/TQM855L.h, branch origin

Fix problems with SNTP support;

2005-04-02T22:37:54+00:00

enable SNTP support in some boards.

Clean up the TQM8xx_YYMHz configurations; allow to use the same

2004-04-24T23:23:30+00:00

binary image for all clock frequencies. Implement run-time
optimization of flash access timing based on the actual bus
frequency.

Fix bootfile default settings for TQM boards

2004-01-31T20:13:31+00:00

Update for TQM board defaults:

2003-08-07T22:18:11+00:00

disable clocks_in_mhz, enable boot count limit

* Add support for NSCU board

2003-07-07T20:07:54+00:00

* Add support for TQM823M, TQM850M, TQM855M and TQM860M modules

* Add support for Am29LV160ML, Am29LV320ML, and Am29LV640ML
  mirror bit flash on TQM8xxM modules

* Get (mostly) rid of CFG_MONITOR_LEN definition; compute real length

2003-05-30T12:48:29+00:00

  instead CFG_MONITOR_LEN is now only used to determine  _at_compile_
  _time_  (!) if the environment is embedded within the U-Boot image,
  or in a separate flash sector.

* Cleanup CFG_DER #defines in config files (wd maintained only)

* Patch by Josef Wagner, 12 Mar 2003:

2003-03-12T10:41:04+00:00

  - 16/32 MB and 50/80 MHz support with auto-detection for IP860
  - ETH05 and BEDBUG support for CU824
  - added support for MicroSys CPC45
  - new BOOTROM/FLASH0 and DOC base for PM826

* Patch by Robert Schwebel, 12 Mar 2003:
  Fix the chpart command on innokom board

* Name cleanup:
  mv include/asm-i386/ppcboot-i386.h include/asm-i386/u-boot-i386.h
  s/PPCBoot/U-Boot/ in some files
  s/pImage/uImage/  in some files

* Patch by Detlev Zundel, 15 Jan 2003:
  Fix '' command line quoting

* Patch by The LEOX team, 19 Jan 2003:
  - add support for the ELPT860 board
  - add support for Dallas ds164x RTC

* Add dual ethernet support on PM826

2003-01-17T16:27:01+00:00

* Add support for LXT971 PHY on PM826

* Patch by Tord Andersson, 16 Jan 2003:
  Fix flash sector count for TQM8xxL

* Fix I2C EEPROM problem on ICU862 board (would only write the first
  16 bytes out of each 32 byte block)

* Use 1-byte-read instead of -write for iprobe() function

2002-12-17T01:51:00+00:00

  Add i2c commands to PM826 config

* extend I2C POST code: check for list on known addresses

Initial revision

2002-10-02T14:20:15+00:00