u-boot.git/include/configs/microblaze-generic.h, branch v2014.10

kconfig: move CONFIG_DEFAULT_DEVICE_TREE to kconfig

2014-09-25T13:31:24Z

This option specifies the default Device Tree used for the run-time configuration of U-Boot. Signed-off-by: Masahiro Yamada Cc: Simon Glass Cc: Stephen Warren Cc: Minkyu Kang Cc: Michal Simek

kconfig: move CONFIG_OF_* to Kconfig

2014-09-25T13:27:50Z

This commit moves: CONFIG_OF_CONTROL CONFIG_OF_SEPARATE CONFIG_OF_EMBED CONFIG_OF_HOSTFILE Because these options are currently not supported for SPL, the "Device Tree Control" menu does not appear in the SPL configuration. Note: zynq-common.h should be adjusted so as not to change the default value of CONFIG_SPL_FAT_LOAD_PAYLOAD_NAME. Signed-off-by: Masahiro Yamada Acked-by: Simon Glass Cc: Stephen Warren Cc: Minkyu Kang Acked-by: Michal Simek

include: remove CONFIG_SPL/CONFIG_TPL definition in config headers

2014-07-30T18:42:03Z

Now CONFIG_SPL and CONFIG_TPL are defined in Kconfig. Remove the redundant definition in config headers. Signed-off-by: Masahiro Yamada Reviewed-by: Simon Glass

kconfig: delete redundant CONFIG_${ARCH} definition

2014-07-30T18:42:02Z

CONFIG_${ARCH} is defined by Kconfig. Signed-off-by: Masahiro Yamada Reviewed-by: Simon Glass

include: define CONFIG_SPL and CONFIG_TPL as 1

2014-07-30T12:48:02Z

We are about to switch to Kconfig in the next commit. But there are something to get done beforehand. In Kconfig, include/generated/autoconf.h defines boolean CONFIG macros as 1. CONFIG_SPL and CONFIG_TPL, if defined, must be set to 1. Otherwise, when switching to Kconfig, the build log would be sprinkled with warning messages like this: warning: "CONFIG_SPL" redefined [enabled by default] Signed-off-by: Masahiro Yamada Reviewed-by: Simon Glass

microblaze: Wire up OF support for emaclite

2014-05-06T11:32:30Z

- expand the condition with CONFIG_OF_CONTROL Signed-off-by: Stephan Linz Acked-by: Simon Glass Signed-off-by: Michal Simek

microblaze: Add SPL support

2014-02-04T15:39:50Z

Add support for U-BOOT SPL. NOR and RAM mode are supported. There are 3 images in NOR flash. u-boot.img, dtb and kernel. Signed-off-by: Michal Simek

microblaze: Enable buffer write for NOR flashes

2014-02-04T15:39:37Z

It speeds up writing a lot. Signed-off-by: Michal Simek

config: remove platform CONFIG_SYS_HZ definition part 2/2

2013-11-04T16:06:16Z

Remove platform CONFIG_SYS_HZ definition for configs a-z*. Signed-off-by: Rob Herring

xilinx: move microblaze-generic .dts to standard location

2013-08-02T22:29:32Z

Aside from microblaze, all other SoCs/boards/vendors store their DT files in board/$vendor/dts/$soc-$board.dts. Move microblaze-generic.dts to this location for consistency. Signed-off-by: Stephen Warren Acked-by: Simon Glass Acked-by: Michal Simek