u-boot.git/include/configs/p2571.h, branch master

ARM: tegra: replace per-device config headers with generic Tegra

2025-04-12T08:11:05+00:00

Most device headers contain SoC specific part and common Tegra post part.
Add a generic header which can be used by any Tegra device of one of the
supported SoC generations (T20, T30, T114, T124 or T210) without need in
device specific configuration.

Signed-off-by: Svyatoslav Ryhel

ARM: tegra: convert CFG_TEGRA_BOARD_STRING into Kconfig option

2025-04-12T06:48:30+00:00

Convert CFG_TEGRA_BOARD_STRING into Kconfig option and move it into device
board Kconfig.

Signed-off-by: Svyatoslav Ryhel

global: Migrate CONFIG_TEGRA_BOARD_STRING to CFG

2022-12-23T15:15:12+00:00

Perform a simple rename of CONFIG_TEGRA_BOARD_STRING to CFG_TEGRA_BOARD_STRING

Signed-off-by: Tom Rini

Convert CONFIG_TEGRA_ENABLE_UARTA et al to Kconfig

2022-12-22T15:31:48+00:00

This converts the following to Kconfig:
   CONFIG_TEGRA_ENABLE_UARTA
   CONFIG_TEGRA_ENABLE_UARTB
   CONFIG_TEGRA_ENABLE_UARTC
   CONFIG_TEGRA_ENABLE_UARTD
   CONFIG_TEGRA_SPI
   CONFIG_TEGRA_UARTA_GPU
   CONFIG_TEGRA_UARTA_SDIO1
   CONFIG_TEGRA_VDD_CORE_TPS62361B_SET3
   CONFIG_TEGRA_VDD_CORE_TPS62366A_SET1

Signed-off-by: Tom Rini

global: Remove unused CONFIG symbols

2022-12-22T15:31:48+00:00

This removes the following unreferenced CONFIG symbols:
   CONFIG_FDTADDR
   CONFIG_FDTFILE
   CONFIG_FLASH_SECTOR_SIZE
   CONFIG_FSL_CPLD
   CONFIG_HDMI_ENCODER_I2C_ADDR
   CONFIG_I2C_MVTWSI
   CONFIG_I2C_RTC_ADDR
   CONFIG_IRAM_END
   CONFIG_IRAM_SIZE
   CONFIG_KSNET_MDIO_PHY_CONFIG_ENABLE
   CONFIG_L1_INIT_RAM
   CONFIG_MACB_SEARCH_PHY
   CONFIG_MIU_2BIT_21_7_INTERLEAVED
   CONFIG_MTD_NAND_VERIFY_WRITE
   CONFIG_MVGBE_PORTS
   CONFIG_NETDEV
   CONFIG_NUM_DSP_CPUS
   CONFIG_PHY_BASE_ADR
   CONFIG_PHY_INTERFACE_MODE
   CONFIG_PSRAM_SCFG
   CONFIG_RAMBOOT_SPIFLASH
   CONFIG_RAMBOOT_TEXT_BASE
   CONFIG_RD_LVL
   CONFIG_ROCKCHIP_SDHCI_MAX_FREQ
   CONFIG_SETUP_INITRD_TAG
   CONFIG_SH_QSPI_BASE
   CONFIG_SMDK5420
   CONFIG_SOCRATES
   CONFIG_SPI_ADDR
   CONFIG_SPI_FLASH_QUAD
   CONFIG_SPI_FLASH_SIZE
   CONFIG_SPI_HALF_DUPLEX
   CONFIG_SPI_N25Q256A_RESET
   CONFIG_TEGRA_SLINK_CTRLS
   CONFIG_TPM_TIS_BASE_ADDRESS
   CONFIG_UBOOT_SECTOR_COUNT
   CONFIG_UBOOT_SECTOR_START
   CONFIG_VAR_SIZE_SPL
   CONFIG_VERY_BIG_RAM

And also:
   BL1_SIZE
   PHY_NO
   RESERVE_BLOCK_SIZE

Signed-off-by: Tom Rini

tegra: Migrate CI_UDC_HAS_HOSTPC to Kconfig

2022-04-08T13:05:19+00:00

This option is only enabled for CI_UDC and !TEGRA20, so implement it as
such in Kconfig directly.

Signed-off-by: Tom Rini 
Reviewed-by: Peter Robinson 
Tested-by: Peter Robinson

Remove CONFIG_SERIAL_MULTI

2021-11-12T19:18:17+00:00

This symbol has been functionally dead for a long time.  Remove the last
and recent re-introductions of setting it, and update the whitelist so
it will not be re-introduced again.

Signed-off-by: Tom Rini

Convert CONFIG_SYS_MMC_ENV_DEV et al to Kconfig

2020-08-08T15:03:52+00:00

This converts the following to Kconfig:
   CONFIG_SYS_MMC_ENV_DEV
   CONFIG_SYS_MMC_ENV_PART

Note that with this conversion we now have consistent behavior with
respect to ensuring that we have always selected the correct MMC
device and hardware partition.

Signed-off-by: Tom Rini

env: Finish migration of common ENV options

2019-11-20T23:32:09+00:00

- In ARMv8 NXP Layerscape platforms we also need to make use of
  CONFIG_SYS_RELOC_GD_ENV_ADDR now, do so.
- On ENV_IS_IN_REMOTE, CONFIG_ENV_OFFSET is never used, drop the define
  to 0.
- Add Kconfig entry for ENV_ADDR.
- Make ENV_ADDR / ENV_OFFSET depend on the env locations that use it.
- Add ENV_xxx_REDUND options that depend on their primary option and
  SYS_REDUNDAND_ENVIRONMENT
- On a number of PowerPC platforms, use SPL_ENV_ADDR not CONFIG_ENV_ADDR
  for the pre-main-U-Boot environment location.
- On ENV_IS_IN_SPI_FLASH, check not for CONFIG_ENV_ADDR being set but
  rather it being non-zero, as it will now be zero by default.
- Rework the env_offset absolute in env/embedded.o to not use
  CONFIG_ENV_OFFSET as it was the only use of ENV_OFFSET within
  ENV_IS_IN_FLASH.
- Migrate all platforms.

Cc: Wolfgang Denk 
Cc: Joe Hershberger 
Cc: Patrick Delaunay 
Cc: uboot-stm32@st-md-mailman.stormreply.com
Signed-off-by: Tom Rini 
Acked-by: Joe Hershberger 
Reviewed-by: Simon Goldschmidt

Convert CONFIG_SF_DEFAULT_* to Kconfig

2019-03-25T21:36:53+00:00

This converts the following to Kconfig:
  CONFIG_SF_DEFAULT_BUS
  CONFIG_SF_DEFAULT_CS
  CONFIG_SF_DEFAULT_MODE
  CONFIG_SF_DEFAULT_SPEED

I use moveconfig script and then manual check on generated u-boot.cfg
to solve the remaining issue.

Signed-off-by: Patrick Delaunay