Signed-off-by: Wolfgang Denk <wd@denx.de>

Simply add some defines, and adjust TLBe setup to include some
space for eLBC NAND.

Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>

eSDHC is mutually exlusive with UART0 (in 4-bits mode) and I2C2
(in 1-bit mode). When eSDHC is used, we should switch u-boot console to
UART1, and make the proper device-tree fixups.

Because of an erratum in prototype boards it is impossible to use eSDHC
without disabling UART0 (which makes it quite easy to 'brick' the board
by simply issung 'setenv hwconfig esdhc', and not able to interact with
U-Boot anylonger).

So, but default we assume that the board is a prototype, which is a most
safe assumption. There is no way to determine board revision from a
register, so we use hwconfig.

Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>

Signed-off-by: Peter Tyser <ptyser@xes-inc.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>

Start of support of
Texas Instruments Software Development Platform(SDP)
for OMAP3430 - SDP3430

Highlights of this platform are:
Flash Memory devices:
	Sibley NOR, Micron 8bit NAND and OneNAND
Connectivity:
	3 UARTs and expanded 4 UART ports + IrDA
	Ethernet, USB
Other peripherals:
	TWL5030 PMIC+Audio+Keypad
	VGA display
Expansion ports:
	Memory devices plugin boards (PISMO)
	Connectivity board for GPS,WLAN etc.
Completely configurable boot sequence and device mapping
etc.

Support default jumpering and:
 - UART1/ttyS0 console(legacy sdp3430 u-boot)
 - UART3/ttyS2 console (matching other boards,
		 and SDP HW docs)
 - Ethernet
 - mmc0
 - NOR boot

Currently the UART1 is enabled by default.  for
compatibility with other OMAP3 u-boot platforms,
enable the #define of CONSOLE_J9.

Conflicts:

	Makefile

Fixed the conflict with smdkc100_config by moving omap_sdp3430_config
to it is alphabetically sorted location above zoom1.

Signed-off-by: David Brownell <david-b@pacbell.net>
Signed-off-by: Nishanth Menon <nm@ti.com>
Signed-off-by: Tom Rix <Tom.Rix@windriver.com>

Forgot to add Copyright while submitting the patch.
This patch adds the copyright.

Signed-off-by: Sandeep Paulraj <s-paulraj@ti.com>

This patch removes the Sequoia "bootstrap" command and replaces it
with the now common command "chip_config".

Please note that the patches with the dynamic PCI sync clock
configuration have to be applied, before this one should go in.
This is because Sequoia has 2 different bootstrap EEPROMs, and
the old bootstrap command configured different values depending
on the detected PCI async clock (33 vs. 66MHz). With the PCI sync
clock patches, this is not necessary anymore. The PCI sync clock
will be configured correctly on-the-fly now.

Signed-off-by: Stefan Roese <sr@denx.de>