A bunch of the 85xx boards have this cruft in them - it's not used
anywhere.  Delete it.

Signed-off-by: Becky Bruce <beckyb@kernel.crashing.org>

This patch adds a default bootargs "fbmem" value to the
CONFIG_BOOTARGS string for the MIMC200 board.

Signed-off-by: Mark Jackson <mpfj@mimc.co.uk>

This patch fixes an ugly behavior of the IL712 magnetic couplers
as used on PLU405. These parts will remember their last state
over a power cycle which might cause unwanted behavior.

Signed-off-by: Matthias Fuchs <matthias.fuchs@esd.eu>
Signed-off-by: Stefan Roese <sr@denx.de>

Both lpd7a400 and lpd7a404 failed to compile because they had
CONFIG_SMC_USE_IOFUNCS defined:

examples/standalone/smc91111_eeprom.c:388: undefined reference to `SMC_outw'

Also removed an orphaned paren in lpd7a404.h

Signed-off-by: Ben Warren <biggerbadderben@gmail.com>

This patch fixes a problem only seen very occasionally on Canyonlands.
The NOR flash interface (CFI driver) doesn't work reliably in all cases.
Erasing and/or programming sometimes doesn't work. Sometimes with
an error message, like "flash not erased" when trying to program an
area that should have just been erased. And sometimes without any error
messages. As mentioned above, this problem was only seen rarely and with
some PLL configuration (CPU speed, EBC speed).

Now I spotted this problem a few times, when running my Canyonlands with
the following setup (chip_config):

1000-nor         - NOR  CPU:1000 PLB: 200 OPB: 100 EBC: 100

Changing the EBC configuration to not release the bus into high
impedance state inbetween the transfers (ATC, DTC and CTC bits set to 1
in EBC0_CFG) seems to fix this problem. I haven't seen any failure
anymore with this patch applied.

Signed-off-by: Stefan Roese <sr@denx.de>
Cc: David Mitchell <dmitchell@amcc.com>
Cc: Jeff Mann <MannJ@embeddedplanet.com>

The comment for the BR0_PRELIM port size initialization incorrectly
stated 32 bit, while it's actually 16 bit. The code is correct.

Reported-by: Guenter Koellner <guenter.koellner@nsn.com>
Signed-off-by: Wolfgang Denk <wd@denx.de>

The patch fixes a compilation warning by defining
CONFIG_SYS_64BIT_VSPRINTF in the config file

Signed-off-by: Sandeep Paulraj <s-paulraj@ti.com>

The patch fixes a compilation warning by defining
CONFIG_SYS_64BIT_VSPRINTF in the config file

Signed-off-by: Sandeep Paulraj <s-paulraj@ti.com>

Extend bootdelay to 10 seconds.  Set boot retry time to 120 seconds and use
reset to retry.  Define default bootcommand and bootargs for production.

Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com>