u-boot.git/include/configs, branch v2018.01-rc1

omap3: evm: Explicitly use DISTRO_DEFAULTS features at startup

2017-12-04T15:23:53+00:00

[primary] Check MMC 0:1 for /extlinux/extlinux.conf and boot
[fallback 1] Check MMC 0:1 zImage and run mmcbootz
[fallback 2] Check MMC 0:1 uImage and run mmcboot
[fallback 3] Check NAND partitions and run nandboot

If 'extlinux.conf' is not found on MMC 0, the previous boot behavior is
followed.

Signed-off-by: Derald D. Woods

ARM: arch-meson: build memory banks using reported memory from registers

2017-12-04T15:17:29+00:00

As discussed at [1], the Amlogic Meson GX SoCs can embed a BL31 firmware
and a secondary BL32 firmware.
Since mid-2017, the reserved memory address of the BL31 firmware was moved
and grown for security reasons.

But mainline U-Boot and Linux has the old address and size fixed.

These SoCs have a register interface to get the two firmware reserved
memory start and sizes.

This patch adds a dynamic reservation of the memory zones in the device tree bootmem
reserved memory zone used by the kernel in early boot.
To be complete, the memory zones are also added to the EFI reserved zones.

Depends on patchset "Add support for Amlogic GXL Based SBCs" at [2].

[1] http://lists.infradead.org/pipermail/linux-amlogic/2017-October/004860.html
[2] http://lists.infradead.org/pipermail/linux-amlogic/2017-November/005410.html

Changes since v1:
- switched the #if to if(IS_ENABLED()) to compile all code paths
- renamed function to meson_board_add_reserved_memory()
- added a mem.h header with comment
- updated all boards ft_board_setup()

Changes since RFC v2:
- reduced preprocessor load
- kept Odroid-C2 static memory mapping as exception

Changes since RFC v1:
- switch to fdt rsv mem table and efi reserve memory
- replaced in_le32 by readl()

Reviewed-by: Simon Glass 
Signed-off-by: Neil Armstrong 
[trini: Fix warning on khadas-vim over missing 
Signed-off-by: Tom Rini

arm: Add Khadas VIM support based on Meson GXL family

2017-12-04T14:59:03+00:00

This adds platform code for the Khadas VIM board based on a
Meson GXL (S905X) SoC with the Meson GXL configuration.

This initial submission supports UART, MMC/SDCard and Ethernet with the
Internal RMII PHY.

The meson-gxl-s905x-khadas-vim.dts is synchronised from the linux 4.13
stable tree as of 4.13.8.

Reviewed-by: Simon Glass 
Signed-off-by: Neil Armstrong

arm: Add LibreTech CC support based on Meson GXL family

2017-12-04T14:59:03+00:00

This adds platform code for the Libre Computer CC "Le Potato" board based on a
Meson GXL (S905X) SoC with the Meson GXL configuration.

This initial submission supports UART, MMC/SDCard and Ethernet with the
Internal RMII PHY.

The meson-gxl-s905x-libretech-cc.dts is synchronised from the linux 4.13
stable tree as of 4.13.8.

Reviewed-by: Simon Glass 
Signed-off-by: Neil Armstrong

add support for Raspberry Pi Zero W

2017-12-04T14:59:02+00:00

Signed-off-by: Dmitry Korunov

rockchip: rk3128: add evb-rk3128 support

2017-11-30T21:55:27+00:00

evb-rk3128 is an evb from Rockchip based on rk3128 SoC:
- 2 USB2.0 Host port;
- 1 HDMI port;
- 2 10/100M eth port;
- 2GB ddr;
- 16GB eMMC;
- UART to USB debug port;

Signed-off-by: Kever Yang 
Acked-by: Philipp Tomsich 
Reviewed-by: Philipp Tomsich

rockchip: rk3128: add soc basic support

2017-11-30T21:55:26+00:00

RK3128 is a SoC from Rockchip with quad-core Cortex-A7 CPU
and mali400 GPU. Support Nand flash, eMMC, SD card, USB 2.0 host
and device, HDMI/LVDS/MIPI display.

Signed-off-by: Kever Yang 
Acked-by: Philipp Tomsich 
Reviewed-by: Philipp Tomsich

Merge branch 'rmobile-mx' of git://git.denx.de/u-boot-sh

2017-11-30T15:39:04+00:00

Merge git://git.denx.de/u-boot-marvell

2017-11-30T15:38:40+00:00

ARM: rmobile: Rework the ULCB CPLD driver

2017-11-30T07:54:18+00:00

Rework the ULCB CPLD driver and make it into a sysreset driver,
since that is what the ULCB CPLD driver is mostly for.

Signed-off-by: Marek Vasut 
Cc: Nobuhiro Iwamatsu