u-boot.git/include/configs, branch v2018.01-rc3

ARM: dts: omap3-evm: Enable DM and devicetree for TMDSEVM{3530, 3730}

2018-01-01T14:04:19Z

This commit updates the configuration files needed to support OF_CONTROL on the OMAP3 EVM baseboard. Additionally: - CONFIG_SYS_THUMB_BUILD is enabled - CONFIG_SPL_ENV_SUPPORT is enabled Tested using GCC 7.2.0 [--with-float=hard --with-mode=thumb]. Signed-off-by: Derald D. Woods

ARM: omap3: evm: Do not relocate FDT address

2018-01-01T14:04:19Z

This commit keeps the 'fdtaddr' as provided by DEFAULT_LINUX_BOOT_ENV. Signed-off-by: Derald D. Woods

Merge git://git.denx.de/u-boot-imx

2017-12-29T14:27:04Z

mx6sxsabresd: Load the correct dtb for revA board

2017-12-29T10:18:59Z

Currently only imx6sx-sdb.dtb is loaded, but if revA board is used the correct dtb is imx6sx-sdb-reva.dtb, so make this possible. While at it, remove an extra 'mmc dev'. Signed-off-by: Fabio Estevam

mx6_common: remove dead code

2017-12-29T10:17:22Z

There is an #ifdef and #endif with nothing in between. This patch simply removes this dead/useless code. Signed-off-by: Adam Ford Reviewed-by: Fabio Estevam

Merge git://git.denx.de/u-boot-dm

2017-12-27T13:17:05Z

Move CONFIG_PANIC_HANG to Kconfig

2017-12-26T18:10:24Z

Freescale (NXP) boards have lots of defconfig files per board. I used "imply PANIC_HANG" for them. Signed-off-by: Masahiro Yamada Reviewed-by: York Sun

boards: ls1046ardb: disable unavailable "ethernet" node in dts

2017-12-24T19:42:50Z

Linux device tree contains "ethernet" node for all possible interface supported by SoC i.e. LS1046A. It is not necessary for a SerDes protocol to support all possible interface. So disable unavailable "ethernet" node in device tree. Also, enable FDT_SEQ_MACADDR_FROM_ENV to fetch MAC address sequentially from environment variables Signed-off-by: Prabhakar Kushwaha Reviewed-by: York Sun

Merge git://git.denx.de/u-boot-sunxi

2017-12-19T12:57:33Z

sunxi: arm64: Increase CONFIG_SYS_BOOTM_LEN to 32MB

2017-12-19T10:56:20Z

The default value of CONFIG_SYS_BOOTM_LEN, 0x800000, causes error when uncompressing Image.gz out of FIT image. Uncompressing Kernel Image ... Error: inflate() returned -5 Image too large: increase CONFIG_SYS_BOOTM_LEN and loading Image out of FIT image. Loading Kernel Image ... Image too large: increase CONFIG_SYS_BOOTM_LEN Must RESET board to recover Signed-off-by: Jagan Teki Acked-by: Maxime Ripard