- Fix latest mainline kernel for rk3308
- Update rk3288-evb config to suport OP-TEE
- Fix for firefly-px30 DEBUG_UART channel and make it standalone
- Script make_fit_atf add python3 support
- Fix rk3328 timer with correct COUNTER_FREQUENCY
- Fix rk3328 ATF support with enable spl-fifo-mode

The arch timer needs COUNTER_FREQUENCY to get correct counter, add it to
make the timer works correct.

Signed-off-by: Kever Yang <kever.yang@rock-chips.com>

Fixes for 2020.01
-----------------
- Fixes for Nitrogen6x
- Fix corruption for mx51evk
- colibri i.MX6: fix broken ESDHC conversion
- mx6sxsabresd: fix broken mmcdev
- imx6q_logic: cleanup boot sequence
- update ATF for imx8mq_evk
- pfuze: fix pmic_get()

Travis CI: https://travis-ci.org/sbabic/u-boot-imx/builds/630007464

The omap3_beagle NAND ECC scheme was changed in 4b37928d357 for unknown
reasons, leading to uncorrectible ecc errors. This commit changes it
back to what it was before.

Signed-off-by: Patrik Dahlström <risca@dalakolonin.se>

Passing earlycon string in the command line may be
useful during bring up, but not after such phase.

Remove the earlycon string to align with the other i.MX SoCs
command lines.

Signed-off-by: Fabio Estevam <festevam@gmail.com>

U-Boot binary has grown in such a way that it goes beyond the reserved
area for the environment variables.

Running "saveenv" followed by a "reset" causes U-Boot to hang because
of this overlap.

Fix this problem by increasing the CONFIG_ENV_OFFSET size.

Also, in order to prevent this same problem to happen in the future,
use CONFIG_BOARD_SIZE_LIMIT, which will detect the overlap in build-time.

CONFIG_BOARD_SIZE_LIMIT does not accept math expressions, so declare
CONFIG_ENV_OFFSET with its direct value instead.

Signed-off-by: Fabio Estevam <festevam@gmail.com>

After the DM conversion the boot SD card is now device 3.

Adjust it so that we can boot the kernel again.

While at it avoid a hardcoded mmc dev inside the finduuid script.

Signed-off-by: Fabio Estevam <festevam@gmail.com>

When compile the curren mainline linux kernel(Linux 5.5-rc3)
with defconfig, the final Image is 29M, it's much
larger than Linux 5.4.

On the current u-boot side on rk3308, the gap between
kernel and fdt is 25M, the fdt will overwrite kernel
Image, so move ftd to a higher memory to give 34M
gab for them.

Signed-off-by: Andy Yan <andy.yan@rock-chips.com>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>

Move BOOTP_DNS2 and PHY_TI from dra7xx_evm.h to
dra7xx_evm_defconfig.

Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
Reviewed-by: Lokesh Vutla <lokeshvutla@ti.com>

This patch provides four configurations which can support U-Boot SPL
to boot from RAM or FLASH and then boot FIT image including OpenSBI
FW_DYNAMIC firmware and U-Boot proper images from RAM or MMC boot devices.

With ae350_rv[32|64]_spl_defconfigs:

U-Boot SPL will be loaded by gdb or FSBL and runs in RAM in machine mode
and then load FIT image from RAM device on AE350.

With ae350_rv[32|64]_spl_xip_defconfigs:

U-Boot SPL can be burned into SPI flash and run in flash in machine mode
and then load FIT image from SPI flash or MMC device on AE350.

Signed-off-by: Rick Chen <rick@andestech.com>
Cc: KC Lin <kclin@andestech.com>
Cc: Alan Kao <alankao@andestech.com>