u-boot.git/include/linux/soc/ti/ti-udma.h, branch main

tree-wide: Replace http:// link with https:// link for ti.com

2023-11-10T16:01:50Z

Replace instances of http://www.ti.com with https://www.ti.com Signed-off-by: Nishanth Menon

dma: ti: k3-udma: Implement dma_get_cfg() interface

2019-12-09T15:47:43Z

Implement dma_get_cfg() interface to pass flow id information for DMA clients to use. This is needed because on K3 SoCs, CPSW (ethernet) and UDMA (DMA provider) support "flows" within a given RX DMA channel. This allows different network packets to be segregated while using same RX DMA channel. In order for basic ethernet to work, CPSW slave must be aware of the flow ID allocated for the RX channel by the DMA driver. This interface allows CPSW to query flow ID from DMA provider and configure it in CPSW HW. Signed-off-by: Vignesh Raghavendra Acked-by: Joe Hershberger Reviewed-by: Grygorii Strashko

dma: ti: add driver to K3 UDMA

2019-04-12T00:07:12Z

The UDMA-P is intended to perform similar (but significantly upgraded) functions as the packet-oriented DMA used on previous SoC devices. The UDMA-P module supports the transmission and reception of various packet types. The UDMA-P also supports acting as both a UTC and UDMA-C for its internal channels. Channels in the UDMA-P can be configured to be either Packet-Based or Third-Party channels on a channel by channel basis. The initial driver supports: - MEM_TO_MEM (TR mode) - DEV_TO_MEM (Packet mode) - MEM_TO_DEV (Packet mode) Signed-off-by: Peter Ujfalusi Signed-off-by: Grygorii Strashko Signed-off-by: Vignesh R