u-boot.git/include/linux/usb, branch v2017.03

fsl/usb: enable usb feature for ls1046ardb

2017-01-18T17:23:24+00:00

Enable usb feature for ls1046ardb

Signed-off-by: Changming Huang 
Reviewed-by: York Sun

usb: xhci: Remove assumption of DWC instance based on DRA7 SoC type

2016-12-03T18:21:10+00:00

Both AM57xx and DRA7xx share the same set of base addresses for DWC
controllers. The usage however differ with DWC2 instance used typically
in AM57xx evms while DWC1 instances used in DRA7x platforms.

Use TARGET_SOC config to differentiate so that CONFIG_AM57XX can be dropped.

Eventually, this needs to be dt-fied.

Signed-off-by: Nishanth Menon 
Signed-off-by: Lokesh Vutla 
Reviewed-by: Tom Rini

drivers: usb: xhci-fsl: Implement Erratum A-010151 for FSL USB3 controller

2016-09-27T21:30:49+00:00

Currently the controller by default enables the Receive Detect feature in P3
mode in USB 3.0 PHY. However, USB 3.0 PHY does not reliably support receive
detection in P3 mode.
Enabling the USB3 controller to configure USB in P2 mode whenever the Receive
Detect feature is required.

Signed-off-by: Sriram Dash 
Signed-off-by: Rajesh Bhagat

drivers: usb: xhci-fsl: Change burst beat and outstanding pipelined transfers requests

2016-09-27T21:30:16+00:00

This is required for better performance, and performs below tuning:
1. Enable burst length set, and define it as 4/8/16.
2. Set burst request limit to 16 requests.

Signed-off-by: Rajesh Bhagat 
Signed-off-by: Sriram Dash

Merge git://git.denx.de/u-boot-fsl-qoriq

2016-09-26T21:10:56+00:00

trini: Drop local memset() from
examples/standalone/mem_to_mem_idma2intr.c

Signed-off-by: Tom Rini

armv8: ls1012a: Convert CONFIG_LS1012A to Kconfig option ARCH_LS1021A

2016-09-26T15:53:07+00:00

Move this config to Kconfig option and clean up existing uses.

Signed-off-by: York Sun 
CC: Calvin Johnson 
CC: Prabhakar Kushwaha 
Reviewed-by: Tom Rini

usb: xhci-rockchip: add rockchip dwc3 controller driver

2016-09-22T13:32:22+00:00

This patch add support for rockchip dwc3 controller, which corresponding
to the two type-C port on rk3399 evb.
Only support usb2.0 currently for we have not enable the usb3.0 phy
driver and PD(fusb302) driver.

Signed-off-by: MengDongyang 
Signed-off-by: Kever Yang 
Reviewed-by: Marek Vasut 
Reviewed-by: Simon Glass

include: usb: Rename USB controller base address mapping

2016-07-26T16:01:04+00:00

Remove Soc specific defines and use generic chasis specific defines
for USB controller base address mapping.

Signed-off-by: Rajesh Bhagat 
Reviewed-by: York Sun

armv8: fsl-layerscape: Add support of QorIQ LS1012A SoC

2016-06-03T21:12:50+00:00

The QorIQ LS1012A processor, optimized for battery-backed or
USB-powered, integrates a single ARM Cortex-A53 core with a hardware
packet forwarding engine and high-speed interfaces to deliver
line-rate networking performance.

This patch add support of LS1012A SoC along with
 - Update platform & DDR clock read logic as per SVR
 - Define MMDC controller register set.
 - Update LUT base address for PCIe
 - Avoid L3 platform cache compilation
 - Update USB address, errata
 - SerDes table
 - Added CSU IDs for SDHC2, SAI-1 to SAI-4

Signed-off-by: Calvin Johnson 
Signed-off-by: Makarand Pawagi 
Signed-off-by: Prabhakar Kushwaha 
Reviewed-by: York Sun

drivers: usb: common: add common code for usb drivers to use

2016-05-17T15:54:43+00:00

Add common usb code which usb drivers makes use of it.

Signed-off-by: Mugunthan V N 
Reviewed-by: Simon Glass