The Amlogic D-PHY in the Amlogic AXG SoC Family does support a frequency
higher than 10MHz for the TX Escape Clock, thus make the target rate
configurable.

This is based on the Linux commit [1] and adapted to the U-Boot driver.

[1] a328ca7e4af3 ("drm/bridge: dw-mipi-dsi: permit configuring the escape clock rate")

Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>

The timing values for dw-dsi are often dependent on the used display and
according to Philippe Cornu will most likely also depend on the used phy
technology in the soc-specific implementation.

To solve this and allow specific implementations to define them as needed
add a new get_timing callback to phy_ops and call this from the dphy_timing
function to retrieve the necessary values for the specific mode.

This is based on the Linux commit [1] and adapted to the U-Boot driver.

[1] 25ed8aeb9c39 ("drm/bridge/synopsys: dsi: driver-specific configuration of phy timings")

Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>

Add new fields "lanes, format & mode_flags" to structure
mipi_dsi_panel_plat.

Signed-off-by: Yannick Fertre <yannick.fertre@st.com>
Reviewed-by: Patrick Delaunay <patrick.delaunay@st.com>

Move this uncommon header out of the common header.

Signed-off-by: Simon Glass <sjg@chromium.org>

Mipi_display.c contains a set of dsi helpers.
This file is a copy of file drm_mipi_dsi.c (linux kernel).

Signed-off-by: Yannick Fertré <yannick.fertre@st.com>