u-boot.git/include/tsec.h, branch v2016.05

net: tsec: Use priv->tbiaddr to initialize TBI PHY address

2016-01-28T18:23:19+00:00

Add a new member 'tbiaddr' to tsec_private struct. For non-DM driver,
it is initialized as CONFIG_SYS_TBIPA_VALUE, but for DM driver, we
can get this from device tree. Update the bindings doc as well.

Signed-off-by: Bin Meng 
Acked-by: Joe Hershberger

net: tsec: Add driver model ethernet support

2016-01-28T18:23:15+00:00

This adds driver model support to Freescale TSEC ethernet driver.

Signed-off-by: Bin Meng 
Reviewed-by: Simon Glass 
Acked-by: Joe Hershberger

net: tsec: Use tsec_private pointer as the parameter for internal routines

2016-01-28T18:23:07+00:00

For internal routines like redundant_init(), startup_tsec() and
init_phy(), change to use tsec_private pointer as the parameter.

Signed-off-by: Bin Meng 
Acked-by: Joe Hershberger

net: tsec: Move rxbd and txbd to struct tsec_private

2016-01-28T18:22:59+00:00

rxbd and txbd are declared static with 8 byte alignment requirement,
but they can be put into struct tsec_private as well and are natually
aligned to 8 byte.

Signed-off-by: Bin Meng 
Acked-by: Joe Hershberger

net: tsec: Move rx_idx and tx_idx to struct tsec_private

2016-01-28T18:22:55+00:00

At present rx_idx and tx_idx are declared as static variables
in the driver codes. To support multiple interfaces, move it to
struct tsec_private.

Signed-off-by: Bin Meng 
Acked-by: Joe Hershberger

net: tsec: fsl_mdio: Fix several cosmetic issues

2016-01-28T18:22:49+00:00

Clean up the tsec and fsl_mdio driver codes a little bit, by:
- Fix misuse of tab and space here and there
- Use correct multi-line comment format
- Replace license identifier to GPL-2.0+

Signed-off-by: Bin Meng 
Acked-by: Joe Hershberger

armv7/ls1021a/etsec: Enable Tx Data and TxBD snooping

2015-08-03T19:06:37+00:00

To improve eTSEC performance on LS1021A Rev2.0,
snooping of all transmit frames from memory and
all transmit BD memory accesses in enabled.

Signed-off-by: Alison Wang 
Reviewed-by: York Sun

net: tsec: Remove tx snooping support from LS1

2014-09-08T17:30:35+00:00

Remove the DMCTRL Tx snooping bits (TDSEN and TBDSEN) as a
workaround for LS1.  It has been observed that currently
the Tx stops functioning after a fair amount of Tx traffic
with these settings on.  These bits are sticky and once set
they cannot be reset from Linux, for instance.

Signed-off-by: Claudiu Manoil

ls102xa: etsec: Add etsec support for LS102xA

2014-09-08T17:30:33+00:00

This patch is to add etsec support for LS102xA. First, Little-endian
descriptor mode should be enabled. So RxBDs and TxBDs are interpreted
with little-endian byte ordering. Second, TSEC_SIZE and TSEC_MDIO_OFFSET
are different from PowerPC, redefine them for LS1021xA.

Signed-off-by: Alison Wang

net: Merge asm/fsl_enet.h into fsl_mdio.h

2014-09-08T17:30:33+00:00

fsl_enet.h defines the mapping of the usual MII management
registers, which are included in the MDIO register block
common to Freescale ethernet controllers. So it shouldn't
depend on the CPU architecture but it should be actually
part of the arch independent fsl_mdio.h.

To remove the arch dependency, merge the content of
asm/fsl_enet.h into fsl_mdio.h.
Some files (like fm_eth.h) were simply including fsl_enet.h
only for phy.h. These were updated to include phy.h instead.

Signed-off-by: Claudiu Manoil