Signed-off-by: Wolfgang Denk <wd@denx.de>

Remove "saveenv" from "update" definition: the environment is outside
the U-Boot image on TQM85xx and therefor not affected by updates.

Also "beautify" code a bit (vertical alignment).

Signed-off-by: Wolfgang Denk <wd@denx.de>

Old TQM85xx boards had 'M' type Spansion Flashes from the S29GLxxxM
series while new boards have 'N' type Flashes from the S29GLxxxN
series, which have bigger sectors: 2 x 128 instead of 2 x 64 KB.

We now change the configuration to the new flash types for all
boards; this also works on old boards - we just waste two flash
sectors for the environment which could be smaller there.

Signed-off-by: Wolfgang Denk <wd@denx.de>

The SYS_CLK_IN of MPC8569MDS is 66.66MHz,
The DDR_CLK_IN is same with SYS_CLK_IN in 8569 processor.
so, change the SYS_CLK_IN from 66MHz to 66.66MHz.

Signed-off-by: Dave Liu <daveliu@freescale.com>

Some boards do not have SROM support for the DM9000 network adapter.
Instead of listing these board names in the driver code, make this
option configurable from the board config file.

It also removes a build warning for the at91sam9261ek board:
'dm9000x.c:545: warning: 'read_srom_word' defined but not used'

And it repaires the trizepsiv board build which was broken around the
same routines

Signed-off-by: Remy Bohmer <linux@bohmer.net>
Signed-off-by: Ben Warren <biggerbadderben@gmail.com>

The mmc code defines the response as an array of chars.  However, it
access the response bytes both as (i) an array of four uints (with
casts) and (ii) as individual chars.  The former case is used more
often, including by the driver when it assigns the response.

The char-wise accesses are broken on little endian systems because they
assume that the bytes in the uints are in big endian byte order.

This patch fixes this by changing the response to be an array of four
uints and replacing the char-wise accesses with equivalent uint-wise
accesses.

Signed-off-by: Rabin Vincent <rabin@rab.in>

A missing set of parenthesis caused the silicon revision to apply only to
the BF533 and not the BF531/BF532 variants.

Signed-off-by: Mike Frysinger <vapier@gentoo.org>

The pins for async memory where parallel flash lives are not enabled by
default, so make sure we mux them as needed.

Signed-off-by: Graf Yang <graf.yang@analog.com>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>

This patch moves the definition for the PPC4xx NAND FLASH controller
(NDFC) CONFIG_NAND_NDFC into include/ppc4xx.h. This is needed for the
upcoming fix for the ECC byte ordering of the NDFC driver.

Signed-off-by: Stefan Roese <sr@denx.de>
Acked-by: Scott Wood <scottwood@freescale.com>