u-boot.git/include, branch v2025.01-rc4

pinctrl: rzg2l: Support Ethernet TXC output enable

2024-12-08T22:06:52+00:00

On the RZ/G2L SoC family, the direction of the Ethernet TXC/TX_CLK
signal is selectable to support an Ethernet PHY operating in either MII
or RGMII mode. By default, the signal is configured as an input and MII
mode is supported. The ETH_MODE register can be modified to configure
this signal as an output to support RGMII mode.

As this signal is be default an input, and can optionally be switched to
an output, it maps neatly onto an `output-enable` property in the device
tree.

Signed-off-by: Paul Barker 
Reviewed-by: Marek Vasut

pinctrl: rzg2l: Support 2.5V PVDD for Ethernet interfaces

2024-12-08T22:06:52+00:00

The Ethenet interfaces on the Renesas RZ/G2L SoC family can operate at
multiple power supply voltages: 3.3V (default value), 2.5V and 1.8V.

rzg2l_pinconf_set() is extended to support the 2.5V setting, with a
check to ensure this is only used on Ethernet interfaces as it is not
supported on the SD & QSPI interfaces.

While we're modifying rzg2l_pinconf_set(), drop the unnecessary default
value for pwr_reg as it is set in every branch of the following if
condition.

Signed-off-by: Paul Barker 
Reviewed-by: Marek Vasut

net: disable MBEDTLS in SPL

2024-12-06T23:47:23+00:00

Building SPL fails with MBEDTLS enabled.
Currently we don't need it there.

Signed-off-by: Heinrich Schuchardt 
Acked-by: Jerome Forissier

Revert "global_data: Drop spl_handoff"

2024-12-02T13:40:39+00:00

This breaks chromebook_coral which says:

   Video: No video mode configured in FSP!

This reverts commit 2e9313179a846b581c0fc3f6a49e19f3d343efa8.

Signed-off-by: Simon Glass

ARM: imx: Perform plain boot in altbootcmd on Data Modul i.MX8M Mini/Plus eDM SBC

2024-11-29T12:19:00+00:00

The current A/B switching preparatory altbootcmd is confusing
to users, replace it with plain 'run bootcmd' which can be
replaced by proper A/B switching altbootcmd when the matching
updater is added on top of the platform. By default, keep the
boot counter incrementing, but do not do any A/B partition
switching.

Signed-off-by: Marek Vasut

arm: mvebu: Add Allied Telesis x250 board

2024-11-26T12:20:03+00:00

The x250 and SE250 are series of 10G L2+ switches from Allied Telesis.
There are a number of them in the range but as far as U-Boot is
concerned all the CPU block components are the same so there's only one
board defined.

Signed-off-by: Chris Packham 
Reviewed-by: Stefan Roese

arm: mvebu: x530: Remove dead comments

2024-11-26T12:20:03+00:00

As things have been moved to Kconfig there are a number of dead comments
left over in x530.h. Remove them.

Signed-off-by: Chris Packham 
Reviewed-by: Stefan Roese

arm: mvebu: x240: Switch to standard boot

2024-11-26T12:20:00+00:00

Use standard boot instead of the distro boot scripts. Regenerate the
board defconfig now that some options are selected automatically.

Signed-off-by: Chris Packham 
Reviewed-by: Stefan Roese

arm: mvebu: x240: Use default baudrate table

2024-11-26T12:19:55+00:00

Remove CFG_SYS_BAUDRATE_TABLE as there's no reason not to use the
defaults defined via config_fallbacks.h.

Signed-off-by: Chris Packham 
Reviewed-by: Stefan Roese

arm: kirkwood: Enable bootstd for Sheevaplug board

2024-11-26T12:19:48+00:00

Enable bootstd for Sheevaplug board.
Remove JFFS2 support. See JFFS2 Vulnerability[1].
Enable LTO to keep board size within limit.
Move default envs to text-base environment

[1] https://lore.kernel.org/u-boot/20241114233005.GN3600562@bill-the-cat/T/#m2fc25da1d2c019bc3cd8676991fdd64b8a21aa9b

Signed-off-by: Tony Dinh 
Reviewed-by: Stefan Roese