Now that the other architecture-specific lib directories have been
moved out of the top-level directory there's not much reason to have the
'_generic' suffix on the common lib directory.

Signed-off-by: Peter Tyser <ptyser@xes-inc.com>

The crc table was being built as little endian for big endian
targets.  This would cause fw_printenv to always fail with
"Warning: Bad CRC, using default environment" messages.

Signed-off-by: Jeff Angielski <jeff@theptrgroup.com>
Acked-by: Joakim Tjernlund <Joakim.Tjernlund@transmode.se>

Ported over the more efficient linux crc32() function.
A quick comparsion on ppc:
After changing the old crc32 to do 4 bytes in the
inner loop to be able to compare with new version one can note:
- old inner loop has 61 insn, new has 19 insn.
- new crc32 does one 32 bit load of data to crc while
  the old does four 8 bits loads.
- size is bit bigger for the new crc32:
  1392(old) 1416(new) of text. The is because the new version
  shares code with crc32_no_comp() instead of duplicating code.
- about 33% faster on ppc:
  New > crc 0 0xfffffff -> 39 secs
  Old > crc 0 0xfffffff -> 60 secs

Signed-off-by: Joakim Tjernlund <Joakim.Tjernlund@transmode.se>

Legacy NAND had been scheduled for removal.  Any boards that use this
were already not building in the previous release due to an #error.

The disk on chip code in common/cmd_doc.c relies on legacy NAND,
and it has also been removed.  There is newer disk on chip code
in drivers/mtd/nand; someone with access to hardware and sufficient
time and motivation can try to get that working, but for now disk
on chip is not supported.

Signed-off-by: Scott Wood <scottwood@freescale.com>

Some systems have zlib.h installed in /usr/include/. This isn't the
desired file for u-boot code - we want the one in include/zlib.h.
This rename will avoid the conflict.

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>

rename CFG_NAND_LEGACY to CONFIG_NAND_LEGACY

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

In the current top-of-tree, 1.3.3.-rc2, the optional tool
'tools/env/fw_printenv' fails to compile for two reasons:

1) The header watchdog.h cannot be found.
2) The header zlib.h is picked up from the tool chain rather than the
   project causing a prototype conflict for crc32.

This patch addresses both of these issues.

Platforms Tested On:
- AMCC "Kilauea"

Signed-off-by: Grant Erickson <gerickson@nuovations.com>

Signed-off-by: Wolfgang Denk <wd@denx.de>

Signed-off-by: Bartlomiej Sieka <tur@semihalf.com>

Signed-off-by: Wolfgang Denk <wd@denx.de>