Currently (since commit b2e2142c) u-boot crashes on
sequoia board while SPR test if CONFIG_4xx_DCACHE is
enabled. This patch disables the cache while SPR test.

Signed-off-by: Anatolij Gustschin <agust@denx.de>

The ECC POST reported intermittent failures running after power-up on
the Korat PPC440EPx board.  Even when the test passed, the debugging
output occasionally reported additional unexpected ECC errors.

This refactoring has three main objectives: (1) minimize the code
executed with ECC enabled during the tests, (2) add more checking of the
results so any unexpected ECC errors would cause the test to fail, and
(3) use synchronization (only) where required by the processor.

Signed-off-by: Larry Johnson <lrj@acm.org>

post/cpu/ppc4xx/spr.c contained a few checks for registers only present
for PPC440 and derivates processor.

Signed-off-by: Niklaus Giger <niklaus.giger@netstal.com>

Signed-off-by: Larry Johnson <lrj@acm.org>

Signed-off-by: Stefan Roese <sr@denx.de>

As repoted by Larry Johnson, running "diag run cache" caused a crash
in U-Boot. This problem was introduced by a patch that removed the
TLB entry for the cache test after the test has completed. Since this
TLB was only setup once, a 2nd attempt to run this cache test
failed with a crash. Now this TLB entry is created every time the
routine is called.

Signed-off-by: Stefan Roese <sr@denx.de>

This patch allows the ECC POST to be used for different boards with the
PPC440 Denali SDRAM controller.  Modifications include skipping the test
if ECC is not enabled (as for non-ECC DIMMs) and adding synchronization
to prevent timing errors.

Signed-off-by: Larry Johnson <lrj@acm.org>

Signed-off-by: Larry Johnson <lrj@acm.org>

Signed-off-by: Matthias Fuchs <matthias.fuchs@esd-electronics.com>

This patch enables the 4xx EMAC POST driver to work too, when dcache is
enabled.

Signed-off-by: Stefan Roese <sr@denx.de>