This includes support for rk3188 from Heiko Stübner and and rk3328 from
Kever Yang.  Also included is SPL support for rk3399 and a fix for
rk3288 to get it booting again (spl_early_init()).

Boards with an apparent need for the md5sum command had the connected
config symbol defined in their board header file.
Move this over to the respective defconfig files now that md5sum is
configured via Kconfig.
(This is a manual effort, which differs from moveconfig.py, not sure
who is right here. Boards except sandbox loose the md5sum command with
moveconfig.py, though it was explicitly mentioned in their config.h's)

Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
[trini: migrate stih410-b2260]
Signed-off-by: Tom Rini <trini@konsulko.com>

Right now the u-boot,dm-pre-reloc flag will make each marked node
always appear in both spl and tpl. But systems needing an additional
tpl might have special constraints for each, like the spl needing to
be very tiny.

So introduce two additional flags to mark nodes for only spl or tpl
environments and introduce a function dm_fdt_pre_reloc to automate
the necessary checks in code instances checking for pre-relocation
flags.

The behaviour of the original flag stays untouched and still marks
a node for both spl and tpl.

Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Reviewed-by: Simon Glass <sjg@chromium.org>
Tested-by: Kever Yang <kever.yang@rock-chips.com>

Xilinx changes for v2017.05

- Move to DM clk driver
- Add clk support for zynq_sdhci

Use Kconfig option instead of config macro in header file.

Signed-off-by: York Sun <york.sun@nxp.com>

Use Kconfig option instead of config macro in header file.
Clean up existing usage.

Signed-off-by: York Sun <york.sun@nxp.com>

Signed-off-by: Tom Rini <trini@konsulko.com>

This moves all of the current ARM errata from various header files and in to
Kconfig.  This allows for a minor amount of cleanup as we had some instances
where both a general common header file was enabling errata as well as the
board config.  We now just select these once at the higher level in Kconfig

Signed-off-by: Tom Rini <trini@konsulko.com>

DTC 1.4.2 or later checks DT unit-address without reg property and
vice-versa, and generates lots of warnings.  Fixing DT files will
take for a while.  Until then, let's turn off the check unless
building with W=*.

Introduce a new helper dtc-option to check if the option is supported
in order to suppress warnings on older versions.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
Tested-by: Bin Meng <bmeng.cn@gmail.com>

This is no longer used anywhere.

Signed-off-by: Tom Rini <trini@konsulko.com>