u-boot.git/test/dm, branch v2016.07-rc1

dm: test: Add GPIO open drain tests

2016-06-04T05:14:20Z

Add some tests for the new open drain setting feature of the GPIO uclass, and extend the capabilities of the sandbox GPIO driver accordingly. Signed-off-by: Mario Six Reviewed-by: Simon Glass Reviewed-by: York Sun

mailbox: implement a sandbox test

2016-05-27T02:48:31Z

This adds a sandbox mailbox implementation (provider), a test client device, instantiates them both from Sandbox's DT, and adds a DM test that excercises everything. Signed-off-by: Stephen Warren Acked-by: Simon Glass # v1

Rename reset to sysreset

2016-05-27T02:48:31Z

The current reset API implements a method to reset the entire system. In the near future, I'd like to introduce code that implements the device tree reset bindings; i.e. the equivalent of the Linux kernel's reset API. This controls resets to individual HW blocks or external chips with reset signals. It doesn't make sense to merge the two APIs into one since they have different semantic purposes. Resolve the naming conflict by renaming the existing reset API to sysreset instead, so the new reset API can be called just reset. Signed-off-by: Stephen Warren Acked-by: Simon Glass

dm: mmc: test: Add tests for MMC

2016-05-17T15:54:43Z

Add a simple test which checks that a sandbox-emulated SD card can be used correctly. This tests plumbing through the MMC stack's block-device implementaion. Signed-off-by: Simon Glass

dm: sandbox: mmc: Enable building MMC code for sandbox

2016-05-17T15:54:43Z

Enable building the MMC code for sandbox. This increases build coverage for sandbox. Signed-off-by: Simon Glass

dm: sandbox: Only enable the sandbox MMC driver when valid

2016-05-17T15:54:43Z

This driver will require generic MMC and block-device support in a future commit. To avoid test errors, make this change now. Signed-off-by: Simon Glass

test/dm/core.c: Make pre-reloc test use pre-reloc struct

2016-04-14T17:51:39Z

LLVM 3.5 noted: test/dm/core.c:41:35: warning: unused variable 'test_pdata_pre_reloc' [-Wunused-const-variable] static const struct dm_test_pdata test_pdata_pre_reloc = { And the correct fix here is that the driver_info_pre_reloc test should use the test_pdata_pre_reloc not test_pdata_manual variable Cc: Simon Glass Signed-off-by: Tom Rini Reviewed-by: Simon Glass

spmi: Add sandbox test driver

2016-04-01T21:18:12Z

This patch adds emulated spmi bus controller with part of pm8916 pmic on it to sandbox and tests validating SPMI uclass. Signed-off-by: Mateusz Kulikowski Reviewed-by: Simon Glass

dm: blk: Add tests for block devices

2016-03-18T03:27:39Z

Add some tests to check that block devices work as expected. Signed-off-by: Simon Glass Tested-by: Stephen Warren

dm: usb: Clean up USB after each test

2016-03-14T21:34:50Z

The USB subsystem has a few counters that need to be reset since they are stored in static variables rather than driver-model data. An example is usb_max_devs. Ultimately we should move this data into the USB uclass. For now, make sure that USB is reset after each test, so that the counters go back to zero. Note: this is not a perfect solution: It a USB test fails it will exit immediately and leave USB un-reset. The impact here is that it may cause subsequence test failures in the same run. Signed-off-by: Simon Glass